High Frequency Magnetometry with an Ensemble of Spin Qubits in Hexagonal Boron Nitride

Charlie J. Patrickson,Simon Baber,Blanka B. Gaál,Andrew J. Ramsay,Isaac J. Luxmoore

DOI: https://doi.org/10.1038/s41534-023-00796-4

2023-06-15

Abstract:Sensors based on spin qubits in 2D crystals offer the prospect of nanoscale sensing volumes, where the close proximity of the sensor and source could provide access to otherwise inaccessible signals. For AC magnetometry, the sensitivity and frequency range is typically limited by the noise spectrum, which determines the qubit coherence time. This poses a problem for III-V materials, as the non-zero spin of the host nuclei introduces a considerable source of magnetic noise. Here, we overcome this with a sensing protocol based on phase modulated continuous concatenated dynamic decoupling, which extends the coherence time towards the $T_1$ limit at room temperature and enables tuneable narrowband AC magnetometry. We demonstrate the protocol with an ensemble of negatively charged boron vacancies in hexagonal boron nitride, detecting in-plane AC fields within $\pm 150~\mathrm{MHz}$ of the electron spin resonance, and out-of-plane fields in the range of $\sim10-150~\mathrm{MHz}$. We measure an AC magnetic field sensitivity of $\sim1~\mathrm{\mu T/\sqrt{Hz}}$ at $\sim2.5~\mathrm{GHz}$, for a sensor volume of $\sim0.1~\mathrm{\mu m^3}$, and demonstrate that the sensor can reconstruct the AC magnetic field from a wire loop antenna. This work establishes the viability of spin defects in 2D materials for high frequency magnetometry, demonstrating sensitivities that are comparable to nitrogen vacancy centres in diamond for microscopic sensing volumes, and with wide-ranging applications across science and technology.

Materials Science

What problem does this paper attempt to address?

The problem that this paper attempts to solve is how to use spin qubits in two - dimensional materials to achieve high - sensitivity and wide - band magnetic measurement in high - frequency magnetic field measurement. Specifically, the paper focuses on how to overcome the influence of noise caused by nuclear spins in materials on the coherence time of spin qubits, thereby improving the performance of the sensor at room temperature. By proposing a technical scheme based on phase - modulated continuous - cascade dynamic decoupling (CCDD), the paper shows how to extend the coherence time of spin qubits to approach the \(T_1\) limit and achieve tunable narrow - band AC magnetic measurement. The paper uses negatively charged boron vacancies (\(V_B^-\)) in hexagonal boron nitride (hBN) as sensors to detect in - plane and perpendicular - to - plane AC magnetic fields with a frequency range from tens of megahertz to several gigahertz, while achieving a sensitivity of about \(1\ \mu\text{T}/\sqrt{\text{Hz}}\) for an estimated sensor volume of only about \(0.1\ \mu\text{m}^3\).

The main contributions of the paper are as follows:
1. **Proposing the phase - modulated CCDD technique**: This technique can significantly extend the coherence time of spin qubits at room temperature, thereby improving the sensitivity of the sensor.
2. **Achieving magnetic measurement in a high - frequency range**: The sensor can detect AC magnetic fields from tens of megahertz to several gigahertz, which is of great significance for many scientific and technological applications.
3. **Demonstrating the practical application ability of the sensor**: It is verified through experiments that the sensor can reconstruct the AC magnetic field from the coil antenna, proving its potential in practical applications.

In general, this paper solves the key problems of improving the sensitivity of the sensor and widening the measurement frequency range in high - frequency magnetic field measurement, providing new ideas and methods for future high - frequency magnetic measurement technologies.