Abstract:In recent years, there has been a rapid growth in new technologies within nuclear medicine and PET diagnostics, particularly in the field of radiopharmaceutical dose preparation. These advancements are driven by the integration of automatic algorithms into the process. This evolution has brought about significant improvements in the efficiency and accuracy of radiopharmaceutical dose preparation. These automatic algorithms utilize state-of-the-art technologies to streamline the process and ensure precise and tailored doses for patients. The integration of these advanced technologies has revolutionized the field, allowing for more effective and personalized treatment options in nuclear medicine and PET diagnostics. By employing automatic radiopharmaceutical dose dispensers (ARDDs), radiation exposure to technologists is minimized while also mitigating the risk of potential infections for patients. Ionization chambers are currently the most used detectors to measure the activity of radiopharmaceuticals in ARDDs. However, they present certain limitations, including size constraints. This study is part of an international endeavor to develop a new approach for evaluating radiopharmaceutical activity in an ARDD named KAR l 100 . A new approach was used to develop a scintillation detector by linking a PVT detector to a SiPMs array consisting of four elements, each having an active surface of 6 × 6 mm with a bias voltage of 30 V. The detection system's amplified output was then fed to a single-channel analyzer called Enviro, developed by Tema Sinergie S.p.A in Italy. The counts per second (CPS) detected by the detector were studied using WinTAM software allowing for the radionuclide's activity concentration to be read out at run-time. Three widely used medical radioisotopes, 18 F, 11 C and 68 Ga, were used to evaluate the performance of the detector in terms of linearity and repeatability of the measurements. Half-life and linear response were evaluated over a wide range of activities with different decay schemes. Data analysis was conducted, resulting in half-lives of the 18 F, 11 C and 68 Ga radioisotopes of 109.75 ± 0.35, 20.62 ± 0.34 and 67.82 ± 0.25 min, respectively, with calculated deviations of 0.0167%, 1.00% and 0.29% from expected values. The linear response of the detector over the entire range of desired activity concentrations was confirmed after data correction for the detector dead time. Calibration of the detector combined with the dispenser system was carried out in parallel investigations to provide the required device properties for reference applications in nuclear medicine. Furthermore, Monte Carlo simulations using FLUKA code were performed to investigate the contribution of beta particles in addition to gamma radiations to assess the influence of beta particles on the calibration factors. For better accuracy, a shielding was designed to prevent any beta particles from reaching the detector.

PDOZ: innovative personal electronic dosimeter for electron and gamma H*(d) dosimetry

Photon Energy Response Optimization Using Few-Channel Spectroscopy Dose Method for Si-PIN Photodetector Applied in Personal Dose Equivalent Measurements

PERSONAL DOSIMETRY USING MONTE-CARLO SIMULATIONS FOR OCCUPATIONAL DOSE MONITORING IN INTERVENTIONAL RADIOLOGY: THE RESULTS OF A PROOF OF CONCEPT IN A CLINICAL SETTING

SENSROC12: A Four-Channel Binary-Output Front-End Readout ASIC for Si-PIN-Based Personal Dosimeters

Active Personal Eye Lens Dosimetry with the Hybrid Pixelated Dosepix Detector

Design and commissioning of a Silicon Photomultiplier-based dosimeter for Low Dose Rate (LDR) oncological brachytherapy

Development of a New Active Personal Dosimeter for Use in Space Radiation Environments

Gamma dose rate monitoring using a Silicon Photomultiplier-based plastic scintillation detector

Design of a Low-Noise Photon-Count Readout ASIC for Si-PIN-Based Personal Dosimeters with Low Energy Detection Threshold

Home-made low-cost dosemeter for photon dose measurements in radiobiological experiments and for education in the field of radiation sciences

Magnetron Sputtered CsPbCl3 Perovskite Detectors as Real-Time Dosimeters for Clinical Radiotherapy

Monte Carlo Simulations of the Energy Response of Γ-Ray Dosimeters with CdZnTe Semiconductor Detectors

Evaluation of basic characteristics of a semiconductor detector for personal radiation dose monitoring

Compact Back-End Electronics with Temperature Compensation and Efficient Data Management for In Situ SiPM-Based Radiation Detection

DOSIMAP: a high-resolution 2-D tissue equivalent dosemeter for linac QA and IMRT verification

Characterisation of a Silicon Photomultiplier Based Oncological Brachytherapy Fibre Dosimeter

The DosiMap, a new 2D scintillating dosimeter for IMRT quality assurance: characterization of two Cerenkov discrimination methods

Design and Development Of Scintillation – Based Gamma Dosimeter Using SIPM Detector

Plastic scintillator-based dosimeters for ultra-high dose rate (UHDR) electron radiotherapy

The DOSIMAP, a high spatial resolution tissue equivalent 2D dosimeter for LINAC QA and IMRT verification

A novel method for accurate and real-time quantification of radiopharmaceutical activity in automated dose dispensers