Estimation of symbol time offset using cyclic prefix in OFDM system

Ivan Cavlek,Sonja Grgic
2023-05-04
Abstract:In this paper synchronization techniques using cyclic prefix (CP) are analyzed to remove the influence of symbol time offset (STO) for correct synchronization in Orthogonal Frequency Division Multiplex (OFDM) system. For correct detection of STO using CP two techniques are used. The first one is based on finding the maximum correlation between two blocks and the second one on finding the similarity between two blocks which is maximized when the difference between them is minimized. Two cases are observed. The first one uses only additive white Gaussian noise (AWGN), while the second also uses the channel impulse response (CIR) of Rayleigh channel. When channel effect is added both performances of estimation by correlation and difference deteriorate if sufficient level of signal to noise (SNR) and proper length of CP are not provided.
Signal Processing
What problem does this paper attempt to address?
This paper aims to solve the Symbol Time Offset (STO) problem in Orthogonal Frequency Division Multiplexing (OFDM) systems. Specifically, the paper analyzes the synchronization techniques using Cyclic Prefix (CP) to eliminate the impact of STO on correct synchronization. To detect STO, the paper proposes two CP - based techniques: one is to find the maximum correlation between two data blocks (Correlation - Based Method, CBM), and the other is to find the similarity between two data blocks, and the similarity reaches the maximum when the difference between them is the smallest (Difference - Based Method, DBM). Two cases are considered in the paper: 1. The case where only Additive White Gaussian Noise (AWGN) exists. 2. The case where there is the Channel Impulse Response (CIR) of the Rayleigh Channel. It is found that when the channel effect is added, if the Signal - to - Noise Ratio (SNR) level is insufficient or the CP length is inappropriate, the estimation performance of both methods will decline. Therefore, ensuring sufficient SNR level and appropriate CP length are crucial for accurate STO estimation.