Real-Time Implementation of Dynamic State Estimation for Microgrid Load Bus Protection

Sarbajit Basu,Arthur K. Barnes,Adam Mate,Olga Lavrova

DOI: https://doi.org/10.1109/KPEC58008.2023.10215393

2024-07-29

Abstract:Inverter-interfaced microgrids, owing to the lack of fault current, cannot be protected using traditional over-current protections, while admittance or differential relaying protection schemes are not practical to be implemented. Dynamic state estimation can track and predict power system transients and has been extensively investigated for setting-less protection. A novel real-time application of dynamic state estimation for protection is proposed in this paper, wherein parameter estimation and parallel processing is used to identify the state of the system. The implementation scheme has low process complexity and employs a data acquisition device and estimator that run on a general-purpose computer. This proposed implementation extends the state-of-the-art, under short-circuit conditions, to a real-time implementation with a lumped-load radial microgrid and a grid-forming inverter with current-limiting behavior.

Systems and Control

What problem does this paper attempt to address?

The paper primarily addresses the issues present in microgrid protection and proposes a real-time implementation scheme based on Dynamic State Estimation (DSE). Specifically, the paper tackles the following key problems:

1. **Failure of Traditional Protection Methods**: Due to the extensive use of inverter-interfaced renewable energy generation devices in microgrids, these devices cannot provide sufficient fault current under fault conditions, leading to the failure of traditional overcurrent protection methods.

2. **Need for New Protection Mechanisms**: The paper points out that existing protection schemes based on impedance or differential relays are not practical in actual applications. Therefore, it is necessary to explore new protection mechanisms to adapt to the characteristics of microgrids.

3. **Application of Dynamic State Estimation**: Utilizing DSE technology can track and predict the transient behavior of the power system, providing the possibility of implementing a protection scheme without setting parameters. The paper proposes a new real-time application scheme that identifies system states through parameter estimation and parallel processing methods.

4. **Implementation Details**: The paper details the implementation process of the scheme, including data acquisition, estimator design, multi-model parallel processing, and communication mechanisms. It emphasizes that the scheme has low processing complexity and can run on general-purpose computers.

5. **Case Studies and Experimental Validation**: By simulating microgrid models under different fault conditions, the proposed DSE scheme is validated to effectively identify various fault types and recommend corresponding protection measures.

In summary, the paper aims to address the challenges brought by the failure of traditional protection methods in microgrids. By introducing dynamic state estimation technology, it proposes a real-time protection scheme and validates its effectiveness and feasibility through experiments.