Abstract:Electronic circuits/systems operating in harsh environments such as space are likely to experience faults or failures due to the impact of high-energy radiation. Given this, to overcome any faults or failures, redundancy is usually employed as a hardening-by-design approach. Moreover, low power and a small silicon footprint are also important considerations for space electronics since these translate into better energy efficiency, less system weight, and less cost. Therefore, the fault-tolerant design of electronic circuits and systems should go hand in hand with the optimization of design metrics, especially for resource-constrained electronics such as those used in space systems. A single circuit or system (also called a simplex implementation) is not fault-tolerant as it may become a single point of failure and is not used for a space application. As an alternative, a triple modular redundancy (TMR) implementation, which uses three identical copies of a circuit or system and a voter to perform majority voting of the circuits and systems outputs, may be used. However, in comparison with a simplex implementation, a TMR implementation consumes about 200% more area and dissipates 200% more power when circuits or systems are triplicated. To mitigate the area and power overheads of a TMR implementation compared to a simplex implementation, researchers have suggested alternative redundancy approaches such as selective TMR (STMR) insertion, partially approximate TMR (PATMR), fully approximate TMR (FATMR), and majority voting-based reduced precision redundancy (VRPR). Among these, VRPR appears to be promising, especially for inherently error-tolerant applications such as digital image/video/audio processing, which is relevant to space systems. However, the alternative redundancy approaches mentioned are unlikely to be suitable for the implementation of control logic. In this work, we analyze various redundancy approaches and evaluate the performance of TMR and VRPR for a digital image processing application. We provide MATLAB-based image processing results corresponding to TMR and VRPR and physical implementation results of functional units based on TMR and VRPR using a 28-nm CMOS technology.

Fault Tolerant FPGA Implementation on Redundancy Techniques and ECG Denoising

Reliability Modeling of Fault-Tolerant FPGA-Based Architectures in Space Applications for Soft and Hard Error Recovery

The Research of FPGA Reliability Based on Redundancy Methods

A survey on Dependable Digital Systems using FPGAs: Current Methods and Challenges

Implementation of decision‐making algorithms in redundant systems on FPGA

Evaluating FPGA-based denoising techniques for improved signal quality in electrocardiograms

FPGA Based Implementation of Distributed Minority and Majority Voting Based Redundancy for Mission and Safety-Critical Applications

Fault-tolerant Technology of SRAM-based FPGA

VHDL Modeling and Analysis of Error-Control Specific Circuits for Multiple-Modular Redundant Systems with Concurrent Error Location Capability

Analysis of Redundancy Techniques for Electronics Design—Case Study of Digital Image Processing

FPGA based Novel High Speed DAQ System Design with Error Correction

On the Optimal Design of Triple Modular Redundancy Logic for SRAM-based FPGAs

Reconfigurable Architectures with High-Frequency Noise Suppression for Wearable ECG Devices

Error Mitigation Using Optimized Redundancy for Composite Algorithms in FPGAs

Soft error detection and correction for parallel digital filters using Hamming code

Towards Reliable AI Applications Via Algorithm-Based Fault Tolerance on NVDLA

Fault Tolerant Parallel Filters Based on Error Correction Codes.

Research on Fault-tolerant Techniques Based on Interwoven Redundancy for Nanoscale Circuits

VLSI implementation of booth multiplier and carry select adder based fir filter design for ECG signal denoising

Reconfigurable Architecture for Multi-lead ECG Signal Compression with High-frequency Noise Reduction

Design and Implementation of Hybrid Techniques and DA-based Reconfigurable FIR Filter Design for Noise Removal in EEG Signals on FPGA