Microstrip Patch Antenna Design at 10 GHz for X Band Applications

Mehmet Karahan,Mertcan Inal,Alperen Dilmen,Furkan Lacinkaya,Ahmet Nuri Akay,Cosku Kasnakoglu

DOI: https://doi.org/10.59324/ejtas.2024.2%281%29.33

2024-02-14

Abstract:Microstrip patch antennas are used in satellite imaging systems, wireless communication equipment, military radios, GPS (Global Positioning System) and GSM (Global System for Mobile Communications) applications. Its advantages are its small size and light weight, thin structure, low power consumption, use in dual frequency applications, and patching in various geometric shapes. Developing technology has facilitated and accelerated the production of microstrip antennas. In this study, microstrip antenna design operating at 10 GHz frequency for X band applications has been made. X band is used for air traffic control, weather traffic control, vessel traffic control, defense tracking and vehicle speed detection, terrestrial communications and networking, space communications and amateur radio. HFSS program was used in antenna design. AWR program was used to find transmission line parameters. In addition, MATLAB program was used to calculate some parameters. First of all, information is given about the working principle of the antenna, the selected dielectric layer and the working frequency. Schematic drawings of the designed antenna were made from above and from the side. S11 reflection coefficient magnitude graphs are drawn below and above the operating frequency. The radiation pattern is drawn for the E-plane and H-plane at the operating frequency. 3-D (dimensional) plot of antenna gain at operating frequency is drawn. The simulations performed have shown that the designed antenna works successfully.

Applied Physics,Signal Processing

What problem does this paper attempt to address?

The paper attempts to address the problem of designing a microstrip patch antenna with a working frequency of 10 GHz for X-band applications. Specifically, the main objectives of the study include:

1. **Designing a high-gain, miniaturized antenna**: To design a microstrip patch antenna that meets the requirements of X-band applications while featuring high gain, small size, thin structure, light weight, and low power consumption.
2. **Verifying antenna performance**: To verify through simulation whether the designed antenna can operate normally at the specified working frequency and meet the design standards of the X-band.
3. **Detailing the design process**: To explain the design principles and structure of the microstrip patch antenna, its advantages in various applications, and to provide a detailed introduction to the software tools used in the design process (such as HFSS, AWR, and MATLAB) as well as the derivation and solution methods of related equations.

In summary, this paper aims to demonstrate how to design and verify a high-performance microstrip patch antenna suitable for X-band applications.