Phase transition kinetics revealed by in situ X-ray diffraction in laser-heated dynamic diamond anvil cells

Matthew Ricks,Arianna E. Gleason,Francesca Miozzi,Hong Yang,Stella Chariton,Vitali B. Prakapenka,Stanislav V. Sinogeikin,Richard L. Sandberg,Wendy L. Mao,Silvia Pandolfi

2024-01-30

Abstract:We report on a novel approach to dynamic compression of materials that bridges the gap between previous static- and dynamic- compression techniques, allowing to explore a wide range of pathways in the pressure-temperature space. By combining a dynamic-diamond anvil cell setup with double-sided laser-heating and in situ X-ray diffraction, we are able to perform dynamic compression at high temperature and characterize structural transitions with unprecedented time resolution. Using this method, we investigate the $\gamma-\epsilon$ phase transition of iron under dynamic compression for the first time, reaching compression rates of hundreds of GPa/s and temperatures of 2000 K. Our results demonstrate a distinct response of the $\gamma-\epsilon$ and $\alpha-\epsilon$ transitions to the high compression rates achieved. These findings open up new avenues to study tailored dynamic compression pathways in the pressure-temperature space and highlight the potential of this platform to capture kinetic effects in a diamond anvil cell.

Materials Science

What problem does this paper attempt to address?

The paper aims to address the following issues:

1. **New Method for Dynamic Compression of Materials**: The paper proposes a novel dynamic diamond anvil cell (dDAC) device, which, combined with double-sided laser heating and in-situ X-ray diffraction techniques, can conduct dynamic compression experiments at high temperatures and study phase transitions of materials under high pressure and high temperature conditions with unprecedented time resolution.

2. **Study of Iron Phase Transitions**: Using this new method, the γ-ϵ phase transition of iron under dynamic compression conditions was studied for the first time, achieving compression rates of several hundred GPa/s and temperatures up to 2000 K. Through this method, the authors discovered that the γ-ϵ and α-ϵ phase transitions respond differently to high compression rates.

3. **Exploration of New Dynamic Effects**: With this device, researchers can explore the dynamic effects of materials under high pressure and high temperature conditions, bridging the gap between static compression and shock compression techniques, and providing valuable experimental benchmark data for validating deformation and strength models.

4. **Phase Transition Behavior at Different Compression Rates**: The study shows that the onset pressure of iron phase transitions varies at different compression rates. Specifically, in the α-ϵ phase transition, the onset pressure increases with the compression rate, whereas no similar phenomenon was observed in the γ-ϵ phase transition.

Through these studies, the paper demonstrates the potential of the dDAC laser heating device in researching high-pressure high-temperature phase transitions and provides new insights into understanding the behavior of materials under extreme conditions.