A Liquid Xenon Positron Target Concept

Max Varverakis,Robert Holtzapple,Hiroki Fujii,Spencer Gessner

DOI: https://doi.org/10.1016/j.nima.2023.168329

2023-03-08

Abstract:Positron targets are a critical component of future Linear Colliders. Traditional targets are composed of high-Z metals that become brittle over time due to constant bombardment by high-power electron beams. We explore the possibility of a liquid xenon target which is continuosly refreshed and therefore not susceptible to the damage mechanisms of traditional solid targets. Using the GEANT4 simulation code, we examine the performance of the liquid xenon target and show that the positron yield is comparable to solid targets when normalized by radiation length. Additionally, we observe that the peak energy deposition density (PEDD) threshold for liquid xenon is higher than for commonly employed metal targets, which makes it an attractive, non-toxic positron target alternative. We develop parameter sets for demonstration applications at FACET-II and future Linear Colliders.

Accelerator Physics

What problem does this paper attempt to address?

This paper explores the feasibility of using liquid xenon (LXe) as a positron target material, aiming to solve the problem that traditional solid high - Z metal target materials in future linear colliders become brittle due to long - term bombardment by high - power electron beams. Specifically, the paper addresses this issue through the following points:

1. **Characteristics of Liquid Xenon**:
- Liquid xenon has a relatively high atomic number (Z = 54) and density (2.953 g/cm³), making its radiation length relatively short and suitable for generating positrons.
- The heat of vaporization of liquid xenon is large, enabling it to absorb more energy without vaporizing, and its peak energy deposition density (PEDD) can exceed 90 J/g, much higher than 35 J/g of traditional metal target materials.
- Liquid xenon can flow continuously, avoiding the degradation problems of solid target materials caused by long - time bombardment.
- Liquid xenon is non - toxic, reducing the need for safety infrastructure.

2. **Simulation and Comparison**:
- Using the GEANT4 simulation software, the performance of liquid xenon target materials and traditional tantalum (Ta) target materials in terms of positron yield and energy deposition was compared.
- The results show that under the same radiation length, the positron yield of liquid xenon target materials is comparable to that of solid target materials.
- The energy deposition density of liquid xenon target materials is relatively high, but the performance can be optimized and the energy deposition can be reduced by selecting an appropriate radiation length.

3. **Energy Deposition and Flow Rate Calculation**:
- The energy deposition of liquid xenon target materials under different experimental conditions was calculated, and an appropriate flow rate was determined to ensure that the target materials will not be damaged due to overheating.
- For different experimental facilities (such as FACET - II, ILC and C3), the flow rate requirements of liquid xenon were calculated to ensure that the energy deposition is within a safe range.

4. **Design of Beryllium Window**:
- The beryllium window is used as the inlet and outlet window of the liquid xenon target material container and needs to be able to withstand the impact of a large number of low - energy particles generated by the liquid xenon target material.
- Through calculation, the energy deposition of the beryllium window under different experimental conditions was determined. It was found that for the C3 experiment, the design of the beryllium window is feasible, while for the ILC experiment, further optimization of the design or adjustment of beam parameters is required.

In conclusion, through detailed simulations and calculations, this paper proves the feasibility of liquid xenon as a new - type positron target material, solves the degradation problem of traditional solid target materials in high - power applications, and proposes specific implementation plans.