Abstract:Beam-based alignment and feedback systems are essential for the operation of the Free Electron Lasers (FELs) and Linear colliders. They require a certain number of beam position monitors (BPMs) at selected locations and that their resolution can reach hundreds of nanometers or even the order of nanometers. Cavity BPMs adopting a resonant cavity structure having the advantage of high position resolution are widely used in the field of accelerators. A typical system includes a cavity BPM pickup, a radio frequency signal conditioning front-end and a digital signal processing electronic. How to systematically analyze the impact of the key parameters of each subsystem on the performance of the whole system, and combine the requirements of the system, operation mode of the facilities, the current level of equipment processing and the development of the electronics, so as to achieve the optimal and balanced allocation of the key technical indicators of each subsystem, is the primary issue to be considered when designing a CBPM system. In this paper, based on theoretical analysis, the relationship between the relative amplitude extraction uncertainty of the CBPM system and the key parameters of each subsystem is proposed, which could provide clear guidance for the design and optimization of a CBPM system. In addition, considering the engineering requirements of the Shanghai High repetition rate X-ray Free Electron Laser and Extreme Light facility (SHINE) for beam position monitor, the allocation of the key technical indicators of the CBPM system using the optimized design method is also introduced. Accordingly, the development of each subsystem was completed, and the beam test bench was also built at the Shanghai Soft X-ray FEL facility (SXFEL), based on the evaluation method of divided power, the beam experiment results show that the position measurement uncertainty of the CBPM system can reach 40 nm at the bunch charge of 100 pC, which is consistent with the theoretical analysis results and better than the requirements of the SHINE.

Continuous-Time Modeling and Analysis of Particle Beam Metrology

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

Beam matching adaptive control via extremum seeking

Time-Resolved Focused Ion Beam Microscopy: Modeling, Estimation Methods, and Analyses

Mitigating Current Variation in Particle Beam Microscopy

Some Progress on Interferometry Techniques Applied to Particle Measurements

Limits of model-based CD-SEM metrology

Research Update: Electron beam-based metrology after CMOS

Accurate Prediction of Mega-Electron-volt Electron Beam Properties from UED Using Machine Learning

Initial PIP-II Beam Current Monitor Fault Case Analyses & Beam Position Monitor Linearity Studies in CST Studio Suite

Optical Considerations for Large 3D Volumetric Particle Tracking Velocimetry

A time-varying approach to single particle tracking with a nonlinear observation model

Beam Size Reconstruction from Ionization Profile Monitors

Beam Profiling with Noise Reduction From Computer Vision and Principal Component Analysis for the MAGIS-100 Experiment

Use of Model-Based Library in Critical Dimension Measurement by CD-SEM

Parametric Modeling and Estimation of Photon Registrations for 3D Imaging

Optical Considerations for Designing Laser-Based Volumetric Particle Tracking Velocimetry

Emittance Minimization for Aberration Correction II: Physics-informed Bayesian Optimization of an Electron Microscope

The Analysis Of Electron Scattering Among Multiplying Layer In Ebaps Using Optimized Monte Carlo Method

Introduction and application of a new approach for model-based optical bidirectional measurements

Optimized Design Method Study for Cavity BPM System