Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Prototype electronics for the silicon pad layers of the future Forward Calorimeter (FoCal) of the ALICE experiment at the LHC

A Large-Scale Pad-Sensor Based Prototype of the Silicon Tungsten Electromagnetic Calorimeter for the Forward Direction in ALICE at LHC

Prototype studies for a forward EM calorimeter in ALICE

Design,fabrication and characterization of 8x9 n-type silicon pad array for sampling calorimetry

ALICE FoCal overview

Performance of the electromagnetic and hadronic prototype segments of the ALICE Forward Calorimeter

Prototype Tests for a Highly Granular Scintillator-Based Hadronic Calorimeter

Design and first experience of the prototype pixel layers for the ALICE FoCal

Development and characterization of a large area silicon pad array for an electromagnetic calorimeter

Beam test of n-type Silicon pad array detector at PS CERN

Physics program and performance of the ALICE Forward Calorimeter upgrade (FoCal)

Testing Highly Integrated Components for the Technological Prototype of the CALICE SiW-ECAL

Performance of a Highly Granular Scintillator-SiPM Based Hadron Calorimeter Prototype in Strong Magnetic Fields

Status of the CALICE analog calorimeter technological prototypes

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

The 1m3 Semidigital Hadronic Prototype

Performance of the Electromagnetic Pixel Calorimeter Prototype EPICAL-2

The Readout Electronics Research Design and Development for CEPC Scintillators Electromagnetic Calorimeter Prototype

Versatile systems for characterization of large-area silicon pad sensors for highly-granular calorimetry

The ILD/CALICE Silicon-Tungsten Electromagnetic Calorimeter: status and potential

FATALIC: A novel CMOS front-end readout ASIC for the ATLAS Tile Calorimeter