Abstract:Traffic loading monitoring plays an important role in bridge structural health monitoring, which is helpful in overloading detection, transportation management, and safety evaluation of transportation infrastructures. Bridge weigh-in-motion (BWIM) is a method that treats traffic loading monitoring as an inverse problem, which identifies the traffic loads of the target bridge by analyzing its dynamic strain responses. To achieve accurate prediction of vehicle loads, the configuration of axles and vehicle velocity must be obtained in advance, which is conventionally acquired via additional axle-detecting sensors. However, problems arise from additional sensors such as fragile stability or expensive maintenance costs, which might plague the implementation of BWIM systems in practice. Although data-driven methods such as neural networks can estimate traffic loadings using only strain sensors, the weight data of vehicles crossing the bridge is difficult to obtain. In order to overcome these limitations, a modified encoder-decoder architecture grafted with signal-reconstruction layer is proposed in this paper to identify the properties of moving vehicles (i.e., velocity, wheelbase, and axle weight) using merely the bridge dynamic response. Encoder-decoder is an unsupervised method extracting higher features from original data. The numerical bridge model based on vehicle-bridge coupling vibration theory is established to illustrate the applicability of this new encoder-decoder method. The identification results demonstrate that the proposed approach can predict traffic loadings without using additional sensors and without requiring vehicle weight labels. Parametric studies also show that this new approach achieves better stability and reliability in identifying the properties of moving vehicles, even under the circumstances of large data pollution.

Signal analysis method of vehicle weigh-in-motion based on EMD-RBF network

Study on Dynamic Weighing System Base on Intelligent Algorithm

Wavelet domain analysis for identification of vehicle axles in the application of BWIM technology

Vehicle Weigh-in-Motion System Based on Soft Capacitive Weighing Sensor

Research on On-Board Dynamic Weighing Algorithm Based on Two-Degree-of-freedom 1/4 Vehicle Model

A signal processing method for dynamic weighing system by SSA-LVQ network

Vehicle weigh-in-motion technology

The Method and Application of a Variational Modal Decomposition Based on Sparrow Search Algorithm

Research on Filtering Algorithm of Vehicle Dynamic Weighing Signal

Research on Data Processing of Dynamic Vehicle Weighbridge with Wavelet Neural Network

Vehicle Signal Analysis Using Artificial Neural Networks for a Bridge Weigh-in-Motion System

Application of Empirical Mode Decomposition(emd) in Data Smoothing for Vehicle Braking

Investigation of Weigh-in-Motion Measurement Accuracy on the Basis of Steering Axle Load Spectra

A New Strategy for Dynamic Weighing in Motion of Railway Vehicles

A Dynamic Weighing Method for Vehicle Scales Based on System Identification

Research on Automotive Dynamic Weighing Method Based on Piezoelectric Sensor

Experimental Platform Development for the Identification of Moving Loads Under the Laboratory Condition

Research on Algorithm of Piezo-Film Vehicle Weigh-in-Motion System

BwimNet: A Novel Method for Identifying Moving Vehicles Utilizing a Modified Encoder-Decoder Architecture

Factors affecting the accuracy of a computer vision-based vehicle weight measurement system

A deep learning method for heavy vehicle load identification using structural dynamic response