Abstract:During the evolution of gearboxes, unwanted noise has been one of the most discussed subjects. Increasing demands on weight reduction and compactness of gearboxes, while preserving the same torque capacity, require optimal design of all parameters involved. Quiet running is especially desirable in a modern automotive gearbox. The very complicated geometry of helical gears, engenders the problem of a multi-variable optimization procedure. Errors of the microform as well as the macroform of the gears highly influence the sound activation. Effects of the macroform have been studied by many researchers and are widely known and predictable. Normally, finishing processes, such as grinding and honing, are used to achieve the predicted macroform of a gear tooth. As a consequence of applying these processes, the microform of the tooth is accomplished.This paper is concerned with the characterization of the gear tooth surfaces obtained with such processes. The characterization is performed with respect to the surface functional properties. These parameters which are interesting due to the noise activity, were identified when the literature available in the field of interest was reviewed. 3D measuring technique, form removal, functional filtering, and 2D spectral density analysis have been utilized in order to extract this information as surface functional parameters.Since the main aim of this paper is to discuss how to produce gears with optimal noise consequences, the principles of RZP-grinding, Fässler honing and Hurth green-shaving are discussed. During this work, the most significant process parameters have been identified utilizing two-level fractional factorial experiments, based on 3D evaluation of surfaces. The parameters identified together with the process principles were then used to predict the surface characteristics. Optimal strategies concerning all processes for production of low noise gears are suggested. The validity of arguments and results regarding the RZP-process was examined, while gears from a real manufacturing shop-floor were evaluated.

Noise of Involute Helical Gears

Computerized Design and Generation of Low-Noise Helical Gears with Modified Surface Topology

Nonlinear vibration of the spiral bevel gear with a novel tooth surface modification method

The Effect of Helical Gear Parameters on the Meshing Noise

Optimization of Gear Tooth Surfaces

A numerical implementation study of the stresses and noise generated by the gear engagement in the gearbox

Effect of the Tooth Surface Waviness on the Dynamics and Structure-Borne Noise of a Spur Gear Pair

New developments in the design and generation of gear drives

Dynamic analysis of a helical gear reduction by experimental and numerical methods

Noise Evaluation of S-Polymer Gears

Noise Evaluation of Coated Polymer Gears

Computerized Design and Analysis of Face-Milled, Uniform Tooth Height Spiral Bevel Gear Drives

Simulation and experiment on vibration of helical gear transmission considering EHD

Analysis of Vibration Characteristic for Helical Gear under Hydrodynamic Conditions

Hobbing Manufacturing of New Type of Involute-Helix Gears for Wind Turbine Gearbox

Effect of Involute Contact Ratio on Spur Gear Dynamics

Investigation on the Dynamic Characteristics of Non-Orthogonal Helical Face Gears with Higher-Order Tooth Surface Modification

Static and Dynamic Transmission Error Measurements of Helical Gear Pairs With Various Tooth Modifications

Research of the Torsion Stiffness of Involute Gear Transmission

Parametric modeling and contact analysis of helical gears with modifications

An Experimental and Theoretical Study of Quasi-Static Behavior of Double-Helical Gear Sets