Abstract:Several dose distribution maps were obtained using a gamma radiation detector mounted to a drone. Based on the results and experience of the experiments, the shortcomings of the system and the possibilities for further development were identified. The primary goal of the development was to create a more compact, easy-to-carry, and easy-to-install system with increased sensitivity, which was achieved by several different methods and their combinations. During the discrete measurement procedure, the aim was to decrease the detection threshold, +0.005 to +0.007 μS/h measured above the background radiation. The increase in sensitivity was based on the characteristic energy spectrum of radiative materials. We took advantage of the fact that the radiating samples do not evenly increase the amount of gamma radiation over the entire energy spectrum. During the processing of the measurement data, we performed a comparison with the background radiation in the vicinity of the energy peaks characteristic of the sample and its decay products. This provides a better signal-to-noise ratio, thus enabling a more sensitive detection procedure. An important feature of our method is that in the traditional intensity curve displayed as a function of flight time only noise is visible, therefore one cannot directly conclude the presence of the sample. However, our method is clearly able to identify the location of the searched source at a height of 8 m with a continuous flight speed of 2 m/s using a 500 μS/h activity sample (as measured at a distance of 0.1 m from the sample). The increase in sensitivity allows either a higher scanning height (approximately +1 to 2 m) or, in the case of the same aircraft at the same altitude, a larger area from one take-off. Of course, the scan height or scan speed can increase significantly if the activity of the source being sought is high. In our experiments, we used a natural uranium mineral (Autunite) with activity far below that of artificially produced isotopes. In the series of our experiments, we also covered the detection of several sources, which modeled the possibility of mapping scattered active sources. The main advantages of the system developed and presented by us over the survey procedures used in practice is that a large area can be mobilized easily, without the risk of a human operator in the field, and the survey of a large area can be carried out at a low cost. The purpose of the system is to detect the presence of the source and to localize it to such an extent that the localization can then be easily refined by manual or other ground procedures. As we do not aim for positioning accuracy by centimeter, standard GPS localization is sufficient for the measurements. During the measurements, the geographical coordinates are interpreted in the GWS'84 system. The coordinates of the latitude and longitude circles are also shown in this system in the figures presented.

Aerial Radiation Reconnaissance with Unknown Isotopic Composition of Contamination and Changing Meteorological Parameters

Airborne gamma-ray spectroscopy for modeling cosmic radiation and effective dose in the lower atmosphere

Estimation of the Vertical Distribution of Radiocesium in Soil on the Basis of the Characteristics of Gamma-Ray Spectra Obtained via Aerial Radiation Monitoring Using an Unmanned Helicopter

Ground Radioactivity Distribution Reconstruction and Dose Rate Estimation Based on Spectrum Deconvolution

Gamma Radiation Dose Measurement Using an Energy-Selective Method with the Help of a Drone

Determination of the dose rate from the pulse-height spectra of an airborne gamma-ray spectrometer based on an unmanned aerial vehicle

Topographic Effects on Ambient Dose Equivalent Rates from Radiocesium Fallout

Fields of View for Environmental Radioactivity

Towards Monte Carlo based Full Spectrum Modeling of Airborne Gamma-Ray Spectrometry Systems

Simulation analysis of the Compton-to-peak method for quantifying radiocesium deposition quantities

Spatial Deconvolution of Aerial Radiometric Survey and its application to the Fallout from a Radiological Dispersal Device

THE USE OF DECONVOLUTION TECHNIQUE FOR THE ANALYSIS OF GAMMA SPECTROMETRY DATA FROM FIELD MONITORING USING UNMANNED AERIAL VEHICLES

First Steps Toward the Verification of Models for the Assessment of the Radiation Exposure at Aviation Altitudes During Quiet Space Weather Conditions

Temporal variation of dose rate distribution around the Fukushima Daiichi nuclear power station using unmanned helicopter

Uncertainty in Aerosol Rainout Processes through the Case of the Radioactive Materials Emitted by the Fukushima Dai-ichi Nuclear Power Plant in March 2011

Characterization of Radiation Exposure at Aviation Flight Altitudes Using the Nowcast of Aerospace Ionizing Radiation System (NAIRAS)

Radiological Mapping of Post-Disaster Nuclear Environments Using Fixed-Wing Unmanned Aerial Systems: A Study From Chornobyl

The Variation of Radiation Effective Dose Rates and Single Event Effect Rates at Aviation Altitudes with Magnetospheric Conditions and Geographic Location

Automatic plume episode identification and cloud shine reconstruction method for ambient gamma dose rates during nuclear accidents

Monte Carlo Simulations of Airborne Gamma Spectrometry of Radionuclide in Earth

Radiological, geochemical, and environmental assessment in Xuancheng, China: The airborne gamma-ray spectrometric view