Abstract:Metalworking is an essential process for the manufacture of machinery and equipment components. The design of the die geometry is an essential aspect of metalworking, and directly affects the resultant product’s quality and cost. As a matter of fact, a comprehensive understanding of the die bearing geometry plays a vital role in the die design process. For the specific case of wire drawing, however, few efforts have been dedicated to the study of the geometry of the bearing zone. In this regard, the present paper involves an attempt to investigate the effects of different geometries of the die bearing. For different forms of reduction as well as bearing zones, measurements are carried out for the wire-drawing process. Subsequently, by extracting the friction coefficients from the electrolytic tough pitch copper wire in cold-drawn essays, the numerical simulations are also implemented. We present the results on both the superficial and center radial tensions obtained by finite element methods. It is observed that the reduction of the friction coefficient leads to an increase in radial stress, while for a given friction coefficient, the substitution of the C-type die by the R-type one results in a decrease in the superficial radial stress of up to 93.27%, but an increase at the center of the material. Moreover, the die angle is found to play a less significant role in the resultant center radial stress, but it significantly affects the superficial radial stress. Lastly, R-type dies result in smaller superficial radial stress, with a change of up to 34.48%, but a slightly larger center radial stress up to 6.55% for different die angles. The implications of the present findings are discussed.

Damage and fracture analyses of wire with off-center inclusion on multi-pass drawing under different back tensions

Stress Intensity Factors for Cracked Cold-drawnSteel Wires under Tensile Loading

Modeling asymmetric fracture mechanics of Mg alloy wire in drawing process

Comparison of reduction ability between multi-stage cold drawing and rolling of stainless steel wire – Experimental and numerical investigations of damage

Relating Residual Stress and Microstructure to Mechanical and Giant Magneto-Impedance Properties in Cold-Drawn Co-based Amorphous Microwires

Analysis of the Causes of Fracture of Hard Wire from High-Carbon Steel 65C

Damage Prediction in the Wire Drawing Process

Copper Wire Multi-Pass Drawing: Process Modeling and Optimization

High deformation and delamination mechanisms explained through mesoscale and nanoscale phenomena in pearlitic steel wires

Experimental Analysis of Wire Drawing Influence on Microstructure, Texture, and Mechanical Properties of High‐Carbon Steel for Prestressing Strand

ANALYSIS OF EFFECT OF ELECTRO-PLASTIC WIRE-DRAWING ON FRICTION AND SURFACE MORPHOLOGY OF THE WIRE

Effect of drawing deformation on microstructure and mechanical properties of Fe-Cr-Co-W alloy

Effect of Microstructure and Microtexture on the Mechanical Properties of Small-Strain Cold-Drawn Pearlite Steel Wires

Hierarchical Structures in Cold-Drawn Pearlitic Steel Wire

Residual Stress Engineering for Wire Drawing of Austenitic Stainless Steel X5CrNi18-10 by Variation in Die Geometries—Effect of Drawing Speed and Process Temperature

Influences of Different Die Bearing Geometries on the Wire-Drawing Process

EVOLUTIONS OF MICROSTRUCTURE AND FERRITIC MICRO--ORIENTATION AND TEXTURE IN A PEARLITIC STEEL WIRE DURING COLD DRAWING

Mechanism for Development of Faults Originating from Compound Inclusions in the Forging Process of 30cr2ni4mov Heavy Ingots

Influence of Tensile Stress on the Circular Magnetization and Eddy-current Anomaly in Fe-rich Soft Wire

The Mechanism of Faults Originating from Inclusions in the Plastic Deformation Processes of Heavy Forging

Impact of hardening law on the FEM prediction of residual stresses in copper-clad aluminum wires