High permeability Performance TFC Nanofiltration Membrane with Two dimensional Nanochannels Support Layer Fabricated by Dissolving of Nanosheets

Run-Hua Tang,Shu-Jun Deng,Sheng-Nan Zhao,Yong Shi,Jing Ye,Gui-E Chen,Zhen-Liang Xu
DOI: https://doi.org/10.1016/j.jece.2024.113553
IF: 7.7
2024-07-14
Journal of Environmental Chemical Engineering
Abstract:A synthesized thin film composite (TFC) nanofiltration membrane was prepared by incorporating Mg(OH) 2 nanosheets at different ratios (from 0 to 0.5 wt%) into polysulfone (PSf) support layer. The polypiperazinamide (PPA) layer was prepared on the polysulfone support layer by means of interfacial polymerization. Then TFC membrane was then etched with H 2 SO 4 and a PPA selective layer was established using trimesoyl chloride (TMC) and piperazine (PIP). The characterization results show that the modifications of the PSf substrate with Mg(OH) 2 alter the physicochemical properties of the poly(piperazine amide) selective layer. Through the introduction of Mg(OH) 2 , the hydrophilicity of the TFC membrane was increased (WCA: 20.5°), promoting more linear polypiperinamide. The addition of 0.4 wt% Mg(OH)2 to the PSf substrate, followed by sulfuric acid etching, resulted in a 196 % increase in membrane flux and with Na2SO4 retention at 97.72 %. The change in matrix composition favoured the generation of a lighter and rougher selective layer. The two-dimensional nanochannels in the support layer provided additional channels for water molecule transport. The membrane with two-dimensional nanochannels exhibited excellent resistance to contamination, with a flux recovery of 92.8 % for bovine serum albumin (BSA).
engineering, chemical, environmental
What problem does this paper attempt to address?