Abstract:Surfactants are widely used in many industrial processes, where the presence of surfactants not only reduces the interfacial tension between fluids but also alters the wetting properties of solid surfaces. To understand how the surfactants influence the droplet motion on a solid surface, a hybrid method for interfacial flows with insoluble surfactants and contact-line dynamics is developed. This method solves immiscible two-phase flows through a lattice Boltzmann color-gradient model and simultaneously solves the convection-diffusion equation for surfactant concentration through a finite difference method. In addition, a dynamic contact angle formulation that describes the dependence of the local contact angle on the surfactant concentration is derived, and the resulting contact angle is enforced by a geometrical wetting condition. Our method is first used to simulate static contact angles for a droplet resting on a solid surface, and the results show that the presence of surfactants can significantly modify surface wettability, especially when the surface is more hydrophilic or more hydrophobic. This is then applied to simulate a surfactant-laden droplet moving on a substrate subject to a linear shear flow for varying effective capillary number ( Cae), Reynolds number ( Re), and surface wettability, where the results are often compared with those of a clean droplet. For varying Cae, the simulations are conducted by considering a neutral surface. At low values of Cae, the droplet eventually reaches a steady deformation and moves at a constant velocity. In either a clean or surfactant-laden case, the moving velocity of the droplet linearly increases with the moving wall velocity, but the slope is always higher (i.e., the droplet moves faster) in the surfactant-laden case where the droplet exhibits a bigger deformation. When Cae is increased beyond a critical value ( Cae,c), the droplet breakup would happen. The presence of surfactants is found to decrease the value of Cae,c, but it shows a non-monotonic effect on the droplet breakup. An increase in Re is able to increase not only droplet deformation but also surfactant dilution. The role of surfactants in the droplet behavior is found to greatly depend upon the surface wettability. For a hydrophilic surface, the presence of surfactants can decrease the wetting length and enables the droplet to reach a steady state faster; while for a hydrophobic surface, it increases the wetting length and delays the departure of the droplet from the solid surface.

Numerical and Experimental Investigation of Static Wetting Morphologies of Aqueous Drops on Lubricated Slippery Surfaces Using a Quasi-Static Approach

Dewetting of Thin Lubricating Films Underneath Aqueous Drops on Slippery Surfaces

Direct visualization of viscous dissipation and wetting ridge geometry on lubricant-infused surfaces

Simple relations for wettability of a droplet on a low-surface-energy solid

J0230203 Analytical consideration of droplet wettability on solid surfaces

Droplet Morphology and Mobility on Lubricant-Impregnated Surfaces: A Molecular Dynamics Study.

Dynamic Wetting and Dewetting of a Low-Energy Surface by Pure Liquids

Experimental Insights into Droplet Behavior on Van der Waals and Non-Van der Waals Liquid-Impregnated Surfaces

Non-isothermal wetting during impact of millimeter size water drop on a flat substrate: numerical investigation and comparison with high-speed visualization experiments

Simulation Analysis on the Profiles of Droplets Wetting on the Substrates

Numerical Study for a Large-Volume Droplet on the Dual-Rough Surface: Apparent Contact Angle, Contact Angle Hysteresis, and Transition Barrier

Dynamic Surface Wetting and Heat Transfer in a Droplet-Particle System of Less Than Unity Size Ratio

Evaporation of Sessile Droplets on Slippery Liquid-Infused Porous Surfaces (SLIPS).

NUMERICAL STUDY ON DYNAMIC WETTABILITY OF MICRO-STRUCTURE SURFACE

Numerical Study of Droplet Dynamics on a Solid Surface with Insoluble Surfactants.

Surface Wetting Study via Pseudocontinuum Modeling

Numerical Investigation on Droplet Wetting Effect With the MPS Method

Numerical Study of the Wetting Dynamics of Droplet on Laser Textured Surfaces: Beyond Classical Wenzel and Cassie-Baxter Model

Dynamic Wettability on the Lubricant-Impregnated Surface: from Nucleation to Growth and Coalescence.

Compare numerical modeling and improved understanding of dynamic sessile drop contact angle analysis in Liquid-Solid-Gas system

Numerical Analysis of Anisotropic Wetting of Chemically Striped Surfaces.