Sliding nanomechanical resonators

Yue Ying,Zhuo-Zhi Zhang,Joel Moser,Zi-Jia Su,Xiang-Xiang Song,Guo-Ping Guo

DOI: https://doi.org/10.1038/s41467-022-34144-5

2022-10-28

Abstract:The motion of a vibrating object is determined by the way it is held. This simple observation has long inspired string instrument makers to create new sounds by devising elegant string clamping mechanisms, whereby the distance between the clamping points is modulated as the string vibrates. At the nanoscale, the simplest way to emulate this principle would be to controllably make nanoresonators slide across their clamping points, which would effectively modulate their vibrating length. Here, we report measurements of flexural vibrations in nanomechanical resonators that reveal such a sliding motion. Surprisingly, the resonant frequency of vibrations draws a loop as a tuning gate voltage is cycled. This behavior indicates that sliding is accompanied by a delayed frequency response of the resonators, making their dynamics richer than that of resonators with fixed clamping points. Our work elucidates the dynamics of nanomechanical resonators with unconventional boundary conditions, and offers opportunities for studying friction at the nanoscale from resonant frequency measurements.

Mesoscale and Nanoscale Physics,Applied Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to understand the dynamic behavior of nano - mechanical resonators under specific boundary conditions, especially how the resonance frequency is affected when its clamping points can slide. Specifically, the authors focused on modulating the resonance frequency of few - layer graphene (FLG) nano - mechanical resonators by changing the gate voltage, and an unprecedented frequency - loop phenomenon was discovered. This phenomenon indicates that as the gate voltage increases and decreases, the resonance frequency of the resonator changes along different paths and forms a closed - loop frequency.

### Main problems

1. **Asymmetry of resonance frequency**: In traditional nano - mechanical resonators, when adjusting the gate voltage, the change in resonance frequency should be symmetric and only depend on the absolute value of the voltage. However, the change in resonance frequency with the gate voltage observed in the experiment shows obvious asymmetry, which suggests the existence of some new physical mechanism.

2. **Formation of frequency loop**: When the gate voltage is gradually increased and then decreased, the resonance frequency does not return along the original path but forms a closed - loop frequency. This phenomenon has not been reported in previous studies and the physical mechanism behind it needs to be explained.

3. **Influence of friction**: The authors speculate that this frequency loop may be related to the sliding of the resonator diaphragm on its supporting substrate, thus introducing additional degrees of freedom of vibration and friction effects. Therefore, studying this phenomenon can provide a new measurement method for friction characteristics at the nano - scale.

### Solutions

To understand these phenomena, the author proposes a mechanical model including a sliding boundary. In this model, the diaphragm of the resonator can slide on the supporting substrate, thus changing the effective length and strain of the suspended part and further affecting the resonance frequency. Specifically:

- **Sliding model**: It is assumed that the diaphragm slides under the action of an electric field, resulting in a change in the length of the suspended part. By introducing springs and dampers to simulate this sliding behavior, the observed frequency - loop phenomenon can be explained.

- **Formula description**:
- Voigt - Kelvin constitutive relation of tension \(T\):
\[
T = kq + c\frac{dq}{dt}
\]
where \(k\) is the spring constant, \(c\) is the damping coefficient, and \(q\) is the elongation of the spring and damper system.

- Expression for resonance frequency \(f\):
\[
f=\frac{1}{2\pi}\sqrt{\frac{8ES}{m_{\text{eff}}L}\left(\frac{3}{4}\frac{x^{2}}{L^{2}} - 2\frac{q}{L}+\epsilon_0\right)}
\]
where \(E\) is Young's modulus, \(S\) is the cross - sectional area of the diaphragm, \(\epsilon_0\) is the built - in strain, \(L\) is the length of the suspended part of graphene, \(x\) is the maximum displacement, and \(m_{\text{eff}}\) is the effective mass of the vibration mode.

Through this model, the author can well reproduce the frequency - loop phenomenon observed in the experiment and estimate the energy loss due to sliding. In addition, they also discuss the relationship between this phenomenon and the friction between two - dimensional materials and solid surfaces, providing new ideas for the study of friction characteristics at low temperatures.

In conclusion, this paper not only reveals a new dynamic behavior of nano - mechanical resonators but also provides an innovative method for studying friction at the nano - scale.