Abstract:This paper studies a multi-antenna network integrated sensing and communication (ISAC) system, in which a set of multi-antenna base stations (BSs) employ the coordinated transmit beamforming to serve their respectively associated single-antenna communication users (CUs), and at the same time reuse the reflected information signals to perform joint target detection. In particular, we consider two target detection scenarios depending on the time synchronization among BSs. In Scenario \uppercase\expandafter{\romannumeral1}, these BSs are synchronized and can exploit the target-reflected signals over both the direct links (from each BS to target to itself) and the cross links (from each BS to target to other BSs) for joint detection. In Scenario \uppercase\expandafter{\romannumeral2}, these BSs are not synchronized and can only utilize target-reflected signals over the direct links for joint detection. For each scenario, we derive the detection probability under a specific false alarm probability at any given target location. Based on the derivation, we optimize the coordinated transmit beamforming at the BSs to maximize the minimum detection probability over a particular target area, while ensuring the minimum signal-to-interference-plus-noise ratio (SINR) constraints at the CUs, subject to the maximum transmit power constraints at the BSs. We use the semi-definite relaxation (SDR) technique to obtain highly-quality solutions to the formulated problems. Numerical results show that for each scenario, the proposed design achieves higher detection probability than the benchmark scheme based on communication design. It is also shown that the time synchronization among BSs is beneficial in enhancing the detection performance as more reflected signal paths are exploited.

A Beam-Space Active Sensing Scheme for Integrated Communication and Sensing Applications

Integrated Sensing and Communication Beamforming Design Based on Mutual Information

Integrated Sensing and Communication with Millimeter Wave Full Duplex Hybrid Beamforming

Joint Beamforming Design for Active RIS-Aided THz ISAC Systems with Delay Alignment Modulation.

Symbiotic Sensing and Communication: Framework and Beamforming Design

Beam Scanning for Integrated Sensing and Communication in IRS-aided mmWave Systems

Joint Transmit and Receive Beamforming Design in Full-Duplex Integrated Sensing and Communications

Robust Integrated Sensing and Communication Beamforming for Dual-functional Radar and Communications: Method and Insights

Integrated Sensing and Communication with Reconfigurable Distributed Antenna and Reflecting Surface: Joint Beamforming and Mode Selection

Hybrid Beamforming for Millimeter Wave MIMO Integrated Sensing and Communications

Integrated Sensing and Communication in Coordinated Cellular Networks

DPC-Inspired Beamforming Design for Integrated Sensing and Communications.

Joint Active and Passive Beamforming Design for Hybrid RIS-Aided Integrated Sensing and Communication

IRS Aided Millimeter-Wave Sensing and Communication: Beam Scanning, Beam Splitting, and Performance Analysis

Multi-Beam Integrated Sensing and Communication: State-of-the-Art, Challenges and Opportunities

Integrated Sensing and Communication for Large Networks using Joint Detection and a Dynamic Transmission Strategy

Sensing-Efficient Transmit Beamforming for ISAC with MIMO Radar and MU-MIMO Communication

Coordinated Transmit Beamforming for Multi-antenna Network Integrated Sensing and Communication

Hybrid Beamforming Design for RSMA-assisted mmWave Integrated Sensing and Communications

Joint Transmit and Receive Beamforming for Integrated Bistatic Radar Sensing and MU-MIMO Communications

IEEE 802.11ay enabled Integrated mmWave Radar Detection and Wireless Communications