Abstract:This paper proposes a novel observer-based controller for Vertical Take-Off and Landing (VTOL) Unmanned Aerial Vehicle (UAV) designed to directly receive measurements from a Vision-Aided Inertial Navigation System (VA-INS) and produce the required thrust and rotational torque inputs. The VA-INS is composed of a vision unit (monocular or stereo camera) and a typical low-cost 6-axis Inertial Measurement Unit (IMU) equipped with an accelerometer and a gyroscope. A major benefit of this approach is its applicability for environments where the Global Positioning System (GPS) is inaccessible. The proposed VTOL-UAV observer utilizes IMU and feature measurements to accurately estimate attitude (orientation), gyroscope bias, position, and linear velocity. Ability to use VA-INS measurements directly makes the proposed observer design more computationally efficient as it obviates the need for attitude and position reconstruction. Once the motion components are estimated, the observer-based controller is used to control the VTOL-UAV attitude, angular velocity, position, and linear velocity guiding the vehicle along the desired trajectory in six degrees of freedom (6 DoF). The closed-loop estimation and the control errors of the observer-based controller are proven to be exponentially stable starting from almost any initial condition. To achieve global and unique VTOL-UAV representation in 6 DoF, the proposed approach is posed on the Lie Group and the design in unit-quaternion is presented. Although the proposed approach is described in a continuous form, the discrete version is provided and tested. Keywords: Vision-aided inertial navigation system, unmanned aerial vehicle, vertical take-off and landing, stochastic, noise, Robotics, control systems, air mobility, observer-based controller algorithm, landmark measurement, exponential stability.

Constructive Equivariant Observer Design for Inertial Velocity-Aided Attitude

Constructive Equivariant Observer Design for Inertial Navigation

Attitude Estimation from Vector Measurements: Necessary and Sufficient Conditions and Convergent Observer Design

Synchronous Observer Design for Inertial Navigation Systems with Almost-Global Convergence

Angular velocity observer design using vector measurements with application to attitude tracking

Nonlinear Attitude Estimation Using Intermittent and Multi-Rate Vector Measurements

Observer-based Controller for VTOL-UAVs Tracking using Direct Vision-Aided Inertial Navigation Measurements

Riccati observers for velocity-aided attitude estimation of accelerated vehicles using coupled velocity measurements

Exponentially Stable Observer-based Controller for VTOL-UAVs without Velocity Measurements

Angular Velocity Observer on the Special Orthogonal Group for Velocity-Free Rigid-Body Attitude Tracking Control

Invariant Observer Design of a RGB-D Aided Inertial System for MAV in GPS-Denied Environments

Constructive Eigenvalue Analysis Based Velocity Observer Design for Mechanical Systems

Asymptotically Stable Observer-based Controller for Attitude Tracking with Systematic Convergence

Velocity-free Attitude Control of Quadrotors: A Nonlinear Negative Imaginary Approach

Observer-based attitude control for reusable launch vehicle with input constraints

A Robust Observer with Gyroscopic Bias Correction for Rotational Dynamics

Attitude Control for a Rigid-Body with Dynamic Disturbance Based on Angular Velocity Observer

A discrete-time attitude observer on SO(3) for vision and GPS fusion

A robust adaptive velocity observer for mechanical systems transformed in cascade form

Rigid Body Attitude Control Using a Single Vector Measurement and Gyro

Geometric Extended State Observer on SE(3) with Fast Finite-Time Stability: Theory and Validation on a Rotorcraft Aerial Vehicle