Abstract:Soil nitrogen is the most limiting nutrient affecting plant growth. However, due to poor soil management due to lack of soil health information, high-N fertilizer use increased exponentially. The UN has labeled nitrogen pollution one of the most important pollution issues facing humanity[1]. Not only does it affect life on land and underwater, it is also 300 times more potent at heating the climate than carbon dioxide while remaining active for 100 years in the atmosphere. Currently, soil nitrogen assessment techniques require destructive sampling where a soil core is collected then shipped to a lab to measure nitrogen content. Not only does this technique have high costs, it only measures nitrogen levels at that specific time point. In this work, we utilized commercially available screen printed electrodes (SPE) with a nitrate ionophore for low cost real-time continuous tracking of soil nitrate levels. The ionophore coating utilizes tetradodecylammonium nitrate (TDDA) as the selective reagent as it’s highly specific to nitrate ions. Previous work done using TDDA used open circuit potential (OCP) to measure nitrate concentration. Soil water content, pH, environmental noise, and other ions impact OCP thus making it unreliable for long term continuous measurements. This work utilizes electrochemical impedance spectroscopy (EIS) instead as it is more robust against the previously mentioned parameters. By opting to use a higher frequency of 1 kHz to extract nitrate concentration, we avoid environmental noise that are dominant at lower frequencies. The sensor output was calibrated in three different soil textures from 2 – 512 ppm presented in Fig. 1(a) for Clay soil. Then the sensor accuracy was validated to the gold standard cadmium reduction method presented in Fig. 1(b) showing non-significant differences with one sample only having a *p-value of 0.049. Lastly, the sensor stability was measured for 7 days continuously in soil with a coefficient of variation of 17% which is under the acceptable standard 20%. Figure 1 (a) Calibrated dose response for Clay soil with 50% water content. (b) vaidation of proposed sensor against gold standard in various soil types. (c) longitudinal study showing stablity and consistency of sensor performance in-situ Figure 1

High-gain observer for the nitrification process including sensor dynamics

MIMO Soft-sensor Model for Nutrient Contents of Compound Fertilizer

MIMO Soft-sensor Model of Nutrient Content for Compound Fertilizer Based on Hybrid Modeling Technique1

Robust Nonlinear Disturbance Observer Design for Estimation of Ammonia Storage Ratio in Selective Catalytic Reduction Systems

Output Stabilization for a Class of Nonlinear Systems Via High-Gain Observer with Limited Gain Power

High-gain Observers with Limited Gain Power for Systems with Observability Canonical Form

A robust hybrid observer for monitoring high-cell density cultures exhibiting overflow metabolism

Projection Algorithm-Based Nonlinear Observation of Internal States in Fuel Delivery Systems with Gas Diffusion

Simultaneous estimation of ammonia injection rate and state of diesel urea-SCR system based on high gain observer

Hybrid multi-observer for improving estimation performance

Real-time monitoring of nitrate in soils as a key for optimization of agricultural productivity and prevention of groundwater pollution

Pressure Sensor Fault Diagnosis by Using Adaptive Robust Observers

An Electrochemical Approach to in-Situ Continuous Soil Nitrate Monitoring

Hybrid dead-beat observers for a class of nonlinear systems

Nonlinear Observers and Applications

An Improved High-Gain Observer Design for Flexible Needle Steering

A New Strategy in Observer Modeling for Greenhouse Cucumber Seedling Growth.

Monitoring Ethanol Fermentation in Real Time by a Robust State Observer for Uncertainties

Modeling the partial nitrification in sequencing batch reactor for biomass adapted to high ammonia concentrations

Modeling coupled nitrification-denitrification in manure-amended soil