SDSS-IV MaNGA : the Impact of Diffuse Ionized Gas on Emission-Line Ratios, Interpretation of Diagnostic Diagrams and Gas Metallicity Measurements
Kai Zhang,Renbin Yan,Kevin Bundy,Matthew Bershady,L. Matthew Haffner,Rene Walterbos,Roberto Maiolino,Christy Tremonti,Daniel Thomas,Niv Drory,Amy Jones,Francesco Belfiore,Sebastian F. Sanchez,Aleksandar M. Diamond-Stanic,Dmitry Bizyaev,Christian Nitschelm,Brett Andrews,Jon Brinkmann,Joel R. Brownstein,Edmond Cheung,Cheng Li,David R. Law,Alexandre Roman Lopes,Daniel Oravetz,Kaike Pan,Thaisa Storchi Bergmann,Audrey Simmons
DOI: https://doi.org/10.1093/mnras/stw3308
2016-01-01
Abstract:Diffuse ionized gas (DIG) is prevalent in star-forming galaxies. Using a sample of 365 nearly face-on star-forming galaxies observed by Mapping Nearby Galaxies at APO, we demonstrate how DIG in star-forming galaxies impacts the measurements of emission-line ratios, hence the interpretation of diagnostic diagrams and gas-phase metallicity measurements. At fixed metallicity, DIG-dominated low Sigma(H alpha) regions display enhanced [S II]/H alpha, [NII]/H alpha, [OII]/H eta and [O I]/H alpha. The gradients in these line ratios are determined by metallicity gradients and O-1 Ha. In line ratio diagnostic diagrams, contamination by DIG moves HII regions towards composite or low-ionization nuclear emission-line region (LI(N) ER)-like regions. A harder ionizing spectrum is needed to explain DIG line ratios. Leaky HII region models can only shift line ratios slightly relative to HII region models, and thus fail to explain the composite/LI(N) ER line ratios displayed by DIG. Our result favours ionization by evolved stars as a major ionization source for DIG with LI(N) ER-like emission. DIG can significantly bias the measurement of gas metallicity and metallicity gradients derived using strong-line methods. Metallicities derived using N2O2 are optimal because they exhibit the smallest bias and error. Using O3N2, R-23, N2 = [N II]/H alpha and N2S2H alpha to derive metallicities introduces bias in the derived metallicity gradients as large as the gradient itself. The strong-line method of Blanc et al. (IZI hereafter) cannot be applied to DIG to get an accurate metallicity because it currently contains only HII region models that fail to describe the DIG.