Abstract:The effect of normal stress variations on fault frictional strength has been extensively characterized in laboratory experiments and modelling studies based on a rate-and-state-dependent fault friction formalism. However, the role of pore pressure changes during injection-induced fault reactivation and associated frictional phenomena is still not well understood. We apply rate-and-state friction (RSF) theory in finite element models to investigate the effect of fluid pressurization rate on fault (re)activation and on the resulting frictional slip characteristics at the laboratory scale. We consider a stepwise injection scenario where each fluid injection cycle consists of a fluid pressurization phase followed by a constant fluid pressure phase. We first calibrate our model formulation to recently published laboratory results of injection-driven shear slip experiments. In a second stage, we perform a parametric study by varying fluid pressurization rates to cover a higher dimensional parameter space. We demonstrate that, for high permeability laboratory samples, the energy release rate associated with fault reactivation can be effectively controlled by a stepwise fluid injection scheme, i.e. by the applied fluid pressurization rate and the duration of the constant pressure phase between each successive fluid pressurization phase. We observe a gradual transition from fault creep to slow stick-slip as the fluid pressurization rate increases. Furthermore, computed peak velocities for an extended range of fluid pressurization rate scenarios (0.5 MPa/min to 10 MPa/min) indicate a non-linear (power-law) relationship between the imposed fluid pressurization rate and the peak slip velocities, and consequently with the energy release rate, for scenarios with a fluid pressurization rate higher than a critical value of 4 MPa/min. We also observe that higher pressurization rates cause a delay in the stress release by the fault. We therefore argue that by adopting a stepwise fluid injection scheme with lower fluid pressurization rates may provide the operator with a better control over potential induced seismicity. The implications for field-scale applications that we can derive from our study are limited by the high matrix and fault permeability of the selected sample and the direct hydraulic connection between the injection well and the fault, which may not necessarily represent the conditions typical for fracture dominated deep geothermal reservoirs. Nevertheless, our results can serve as a basis for further laboratory experiments and field-scale modelling studies focused on better understanding the impact of stepwise injection protocols on fluid injection-induced seismicity.

Fault friction under thermal pressurization during large coseismic-slip Part I: Numerical analyses

Fault friction during simulated seismic slip pulses

Two sides of a fault: Grain-scale analysis of pore pressure control on fault slip

The physics of fault friction: Insights from experiments on simulated gouges at low shearing velocities

A proxy implementation of thermal pressurization for earthquake cycle modeling on rate-and-state faults

The Role of Thermal Pressurization and Dilatancy in Controlling the Rate of Fault Slip

Hydrodynamics of fault gouges from constitutive modelling to the physics of friction

Transient evolution of permeability and friction in a slowly slipping fault activated by fluid pressurization

A Discrete Elements Study of the Frictional Behavior of Fault Gouges

Fluid-driven slow slip and earthquake nucleation on a slip-weakening circular fault

How does thermal pressurization of pore fluids affect 3D strike-slip earthquake dynamics and ground motions?

Transient and Steady‐State Friction in Non‐Isobaric Conditions

Numerical investigation of the effect of fluid pressurization rate on laboratory-scale injection-induced fault slip

Numerical investigation of frictional heating effect on the earthquake faulting based on the Ruina- and Chester-Higgs- models

How Fault‐Normal and Shear‐Parallel Stiffness Influence Frictional Sliding Behavior

Does the direct effect of friction increase continuously with absolute temperature?

A phase-field model of frictional shear fracture in geologic materials

Hydro-mechanical earthquake cycles in a poro-visco-elasto-plastic fluid-bearing fault structure

Spatially variable fault friction derived from dynamic modeling of aseismic afterslip due to the 2004 Parkfield earthquake

Qualitative study of a geodynamical rate-and-state model for elastoplastic shear flows in crustal faults

Coseismic fault sealing and fluid pressurization during earthquakes