Tension tuning of sound and heat transport in graphene

H. Liu,M. Lee,M. Šiškins,H. S. J. van der Zant,P. G. Steeneken,G. J. Verbiest

DOI: https://doi.org/10.48550/arXiv.2204.06877

2022-04-14

Abstract:Heat transport by acoustic phonons in 2D materials is fundamentally different from that in 3D crystals because the out-of-plane phonons propagate in a unique way that strongly depends on tension and bending rigidity. Since in-plane and out-of-plane phonon baths are decoupled, initial studies suggested they provide independent pathways for heat transport and storage in 2D materials. Here, we induce tension in freestanding graphene membranes by electrostatic force, and use optomechanical techniques to demonstrate that it can change the rate of heat transport by as much as 33%. Using a ballistic Debye model, we account for these observations and extract the average bending rigidity of the flexural acoustic phonons, which increases approximately linearly with the membrane's areal mass density, in contrast to the cubic dependence seen in bulk structures. Thus, we not only elucidate phononic heat transport mechanisms in suspended 2D materials, but also provide a promising route for controlling nanoscale heat transport by tension.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

### What problems does this paper attempt to solve?

This paper aims to explore the regulation mechanism of phonon thermal transport in two - dimensional materials (especially graphene). Specifically, the author induces tension on a freely - suspended graphene membrane by applying an electric field force and uses optomechanical techniques to study the influence of this tension on the thermal transport rate. The following are the main problems and objectives of this study:

1. **Phonon thermal transport mechanism in two - dimensional materials**:
- It has been found that in two - dimensional materials, the propagation characteristics of in - plane phonons and out - of - plane flexural phonons are significantly different, which is essentially different from the situation in three - dimensional crystals.
- The propagation speed of out - of - plane flexural phonons is mainly determined by tension and can be an order of magnitude lower than that of in - plane phonons.

2. **The influence of tension on the thermal transport rate**:
- The author has experimentally demonstrated that tension can change the thermal transport rate, with a maximum change of up to 33%.
- These observations are explained using the Debye model, and the relationship between the flexural rigidity and the mass density of the membrane is extracted.

3. **Characterization of the microscopic thermal transport mechanism**:
- By measuring the resonance frequencies, thermal time constants, and effective thermal expansion coefficients of four graphene drum oscillators, the author has established a microscopic model of phonon thermal transport.
- The model takes into account the effects of ballistic transport, boundary scattering, and flexural rigidity on two - dimensional thermal transport.

4. **Application prospects**:
- This study not only reveals the mechanism of phonon thermal transport in suspended two - dimensional materials but also provides a promising approach for the control of nanoscale thermal transport.
- The results are helpful for the development of controllable and optimized thermal management techniques, which are applied in phononics, thermoelectric, electronic, and quantum devices based on two - dimensional materials.

### Formula summary

- **The change of resonance frequency with gate voltage**:
\[
\omega_0(V_g)=\sqrt{\frac{1}{m_{\text{eff}}}\left[\frac{2\pi E_t\epsilon_0}{1 - \nu^2}+\frac{8\pi E_t}{(1 - \nu^2)r^2z_g^2}-\frac{1}{2}\frac{\partial^2C_g}{\partial z_g^2}V_g^2\right]}
\]

- **Calculation of the thermal time constant**:
\[
\tau=\frac{r}{2}\sum_j w_{1z\rightarrow2j}c_{z,j}
\]
where \(w_{1z\rightarrow2j}\) is the probability of flexural phonons being transmitted from the suspended part to the supporting part, and \(c_{z,j}\) is the speed of different types of phonons.

- **Dispersion relation of flexural phonons**:
\[
\omega_q=\sqrt{\frac{\kappa q^4 + nq^2}{\eta\rho_g}}
\]
where \(\kappa\) is the flexural rigidity, \(q\) is the wave vector, and \(\eta\) is the normalized areal mass density.

Through these formulas and experimental data, the author has successfully demonstrated how to tune phonon thermal transport in two - dimensional materials by tension, thus providing new ideas for future thermal management and nanodevice design.