Abstract:In this study, we use discrete dislocation dynamics (DDD) simulation to investigate the effect of heterogeneous dislocation density on the transition between quasi-elastic deformation and plastic flow in face-centered cubic single crystals. By analyzing the stress-strain curves of samples with an initial, axial dislocation density gradient, we arrive at the following conclusions: (i) in the regime of quasi-elastic deformation before the onset of plastic flow, the effective elastic modulus of the simulated samples falls significantly below the value for a dislocation-free crystal. This modulus reduction increases with decreasing dislocation density gradient: crystals with homogeneous dislocation distribution are thus weakest in the quasi-elastic regime; (ii) the transition towards plastic flow occurs first in regions of reduced dislocation density. Therefore, the overall yield stress decreases with increasing dislocation density gradient; (iii) crystals with dislocation density gradient exhibit a more pronounced hardening stage during which stress is re-distributed onto stronger regions with higher dislocation density until the sample flows at a constant flow stress that is approximately independent on dislocation density gradient. We interpret these findings in terms of a continuum dislocation dynamics inspired model of dislocation density evolution that accounts for inversive dislocation motions. The transition between quasi-elastic and plastic deformation is interpreted as a transition from inversive to non-inversive dislocation motion, and the initial differences in elastic modulus are related to a density dependent polarizability of the dislocation system. The subsequent plastic flow behavior is analyzed in terms of a modified version of Mughrabi's composite model.

On the Origin of Plasticity-Induced Microstructure Change under Sliding Contacts

Molecular Dynamic Study Of Microstructure Evolution Of Crystalline Material During Contact Sliding

High Strain Gradient Plasticity Associated with Wedge Indentation into Face-Centered Cubic Single Crystals: Geometrically Necessary Dislocation Densities

Localised stress and strain distribution in sliding

Evolution of tribo-magnetization during sliding of ferromagnetic materials

Creep to inertia dominated stick-slip behavior in sliding friction modulated by tilted non-uniform loading

Interfacial plasticity controls material removal rate during adhesive sliding contact

Quantitative Investigations on Dislocation Based Discrete-Continuous Model of Crystal Plasticity at Submicron Scale

Insight into indentation-induced plastic flow in austenitic stainless steel

Thermomechanical modeling and transient analysis of sliding contacts between an elastic–plastic asperity and a rigid isothermal flat

Frictional contact and stick-slip: mechanism and numerical technology

Inelastic Contact Behaviors of Nanosized Single-Asperity and Multi-Asperity on Α-Fe Surface: Molecular Dynamic Simulations

Statistical analysis of Discrete Dislocation Dynamics simulations: initial structures, cross-slip and microstructure evolution

A multi-scale computational model of crystal plasticity at submicron-to-nanometer scales

Microplasticity and yielding in crystals with heterogeneous dislocation distribution

Crystal Plasticity Finite Element Method for Slip Systems Evolution Analysis of / Duplex Titanium Alloys during Quasi-Static Tensile Testing

How collective asperity detachments nucleate slip at frictional interfaces

Prismatic-to-basal plastic slip transition in zirconium

Tribological behavior anisotropy in sliding interaction of asperities on single-crystal α-iron: A quasi-continuum study

A stochastic discrete slip approach to microplasticity: Application to submicron W pillars

Surface plastic flow in polishing of rough surfaces