Abstract:We are developing and investigating an Immunological Ion Sensitive Field Effect Transistor (Im-ISFET) based on graphene grown by CVD and subsequently transferred to desired substrates including transparent foils as in Fig. 1. This Im-ISFET allows us to measure both the current (I-V measurement) through the graphene and the capacitance (C-V measurement) on its surface [1].The measurement setup is schematically shown in Fig. 2. Through C-V measurement, the potential drop over the Electrical Double Layer (EDL) and the capacitance of it are obtained simultaneously. This gives more information about the adsorption of molecules on the graphene surface, and will forward our understanding of the binding of targets to the graphene surface which in turn will give us a deeper understanding of what the measured signals may tell. Performing C-V measurement with Si-based structures is difficult since a thick oxide layer is necessary to prohibit uncontrolled redox reactions on the surface. This oxide layer has a much smaller capacitance than the EDL capacitance. When measured in series with the EDL capacitance, the oxide capacitance dominates and renders the EDL capacitance undetectable. The use of graphene as the channel material overcomes this challenge. Graphene is much more chemically inert and does not need passivation against electrolytes. A capacitance measurement then only contains two terms: the quantum capacitance of graphene and the EDL capacitance. These two capacitance components are of the same order of magnitude and this enables capacitance measurement of the binding process. Our focus in this work is on DNA sensing. To make a DNA sensor, it is necessary to bind the DNA probe to the graphene surface via a linker layer. We have employed two different approaches to achieve this layer. One approach is to rely on a self-assembled monolayer (SAM) of an organic molecule 1-pyrenebutanoic acid succinimidyl ester (PYR-NHS)[2]. PYR-NHS has a pyrene group that binds to graphene through pi-pi stacking[3], and a carboxylic group activated by a succinimidyl ester that binds to the probe DNA. The functionalization is done through wet chemistry at room temperature and can be combined with in situ electrical measurements to characterize the coverage of the PYRNHS. The coverage is also measured by AFM, XPS, SEM, and fluorescence measurement. The fluorescence experiment is carried out by attaching the probe DNA onto a predetermined pattern and then measuring the fluorescence intensity of the labeled target DNA. The selectivity of DNA binding is characterized by measuring the fluorescence intensity on the spots with and without the probe DNA, as seen in Fig. 3. Characterization of the films will also be performed through XPS and SEM. Another approach is to deposit a thin layer of Au on graphene. The Au layer is so thin that it becomes non-percolating islands spread over the graphene surface. Thiol-based chemistry is then used to attach the DNA probe to the Au. The thiol-chemistry is well established for attaching organic molecules to Au in biochemistry. We have deposited Au layers of different nominal thicknesses by electron-beam evaporation, in order to find a suitable thickness window for sensing. The Au layers are characterized using SEM, grazing incident small angle x-ray scattering (GISAXS) and electrical measurements. An example of the GISAXS measurement is shown in the upper panel of Fig. 4, while the setup and working principle are illustrated in the lower panel of Fig. 4. References [1] Chen, S., et al., Applied Physics Letters, 101 (2012) 154106/1-3. [2] Ohno, Y., et al., Journal of the American Chemical Society, 132 (2010) 18012–3. [3] Chen, R. J., et al., Journal of the American Chemical Society, 123 (2001) 3838–9. Au 4

Multi-dimensional microwave sensing using graphene waveguides

Electrochemically-gated Graphene Broadband Microwave Waveguides for Ultrasensitive Biosensing

Multi-sensor integration on one microfluidics chip for single-stranded DNA detection

Label-free terahertz microfluidic biosensor for sensitive DNA detection using graphene-metasurface hybrid structures

Functionalization of Graphene towards Dual-Mode Bio-Sensing

Dielectric‐Modulated Biosensing with Ultrahigh‐Frequency‐Operated Graphene Field‐Effect Transistors

An Integrated Sensing System for Detection of Dna Using New Parallel-Motif Dna Triplex System and Graphene-Mesoporous Silica-Gold Nanoparticle Hybrids

Optical Conductivity-Based Ultrasensitive Mid-Infrared Biosensing on a Hybrid Metasurface

A Monolithic Graphene Functionalized Microlaser for Multispecies Gas Detection

Molecular Spectrum Capture by Tuning the Chemical Potential of Graphene

Surface-tailored graphene channels

Real-time reliable determination of binding kinetics of DNA hybridization using a multi-channel graphene biosensor

Biochemical Sensing in Graphene-Enhanced Microfiber Resonators with Individual Molecule Sensitivity and Selectivity

Ultrasensitive Mid‐infrared Biosensing in Aqueous Solutions with Graphene Plasmon

Designing a Graphene Metasurface Organic Material Sensor for Detection of Organic Compounds in Wastewater

Magnetic Graphene Field-Effect Transistor Biosensor for Single-Strand DNA Detection

Electrically Tunable Four-Wave-Mixing in Graphene Heterogeneous Fiber for Individual Gas Molecule Detection

Plasmonic Biosensor for DNA Hybridization Using Integrated Graphene-Porous Silicon Waveguide

Sensing at the Surface of Graphene Field-Effect Transistors.

Surface-acoustic-wave-driven graphene plasmonic sensor for fingerprinting ultrathin biolayers down to the monolayer limit

Wafer-scale graphene field-effect transistor biosensor arrays with monolithic CMOS readout