Raman Imaging of Atoms Inside a High-bandwidth Cavity

Eduardo Uruñuela,Maximilian Ammenwerth,Pooja Malik,Lukas Ahlheit,Hannes Pfeifer,Wolfgang Alt,Dieter Meschede

DOI: https://doi.org/10.1103/PhysRevA.105.043321

2022-02-18

Abstract:High-bandwidth, fiber-based optical cavities are a promising building block for future quantum networks. They are used to resonantly couple stationary qubits such as single or multiple atoms with photons routing quantum information into a fiber network at high rates. In high-bandwidth cavities, standard fluorescence imaging on the atom-cavity resonance line for controlling atom positions is impaired since the Purcell effect strongly suppresses all-directional fluorescence. Here, we restore imaging of $^{87}$Rb atoms strongly coupled to such a fiber Fabry-Pérot cavity by detecting the repumper fluorescence which is generated by continuous and three-dimensional Raman sideband cooling. We have carried out a detailed spectroscopic investigation of the repumper-induced differential light shifts affecting the Raman resonance, dependent on intensity and detuning. Our analysis identifies a compromise regime between imaging signal-to-noise ratio and survival rate, where physical insight into the role of dipole-force fluctuations in the heating dynamics of trapped atoms is gained.

Quantum Physics,Atomic Physics

What problem does this paper attempt to address?

This paper attempts to solve the problem of imaging atoms in high - bandwidth fiber Fabry - Perot cavities (FFPCs). Specifically, the paper focuses on how to recover the imaging of 87Rb atoms under strong - coupling conditions, because in high - bandwidth cavities, due to the Purcell effect, omnidirectional fluorescence is strongly suppressed, and traditional fluorescence imaging methods cannot effectively control the atomic position. To overcome this challenge, the authors introduce a new imaging technique, that is, achieving atomic imaging by detecting the repumping fluorescence generated during the continuous three - dimensional Raman sideband cooling process.

### Main problems
1. **Fluorescence suppression caused by the Purcell effect**: In high - bandwidth cavities, due to the Purcell effect, the fluorescence of atoms on the resonance line is strongly suppressed, which makes traditional fluorescence imaging methods ineffective.
2. **Balance between imaging and cooling**: While achieving imaging, it is necessary to maintain the cooling state of atoms to reduce atomic losses caused by heating.

### Solutions
1. **Repumping fluorescence imaging**: By detecting the repumping fluorescence generated during the continuous three - dimensional Raman sideband cooling process, the imaging of atoms can be recovered. This method is not affected by the Purcell effect because the repumping fluorescence is generated in transitions far from the resonance line.
2. **Parameter optimization**: By optimizing the intensity and detuning of the repumping laser, the best balance point between the imaging signal - to - noise ratio and the atomic survival rate is found. The authors have studied in detail the differential optical frequency shifts caused by repumping and how these shifts affect the Raman resonance conditions, thereby optimizing the imaging and cooling processes.

### Specific methods
- **Experimental setup**: Use a one - sided high - bandwidth fiber Fabry - Perot cavity, in which 87Rb atoms are trapped in a 3D optical lattice and strongly coupled to the cavity field.
- **Raman sideband cooling**: Achieve three - dimensional Raman sideband cooling through two Raman beams (RB1 and RB2), and at the same time use a repumping beam (795 nm) to induce atoms to scatter photons, which are collected for imaging.
- **Parameter optimization**: Optimize the imaging signal - to - noise ratio and the atomic survival rate by adjusting the intensity and detuning of the repumping light. The authors have also studied the differential optical frequency shifts caused by repumping, which will affect the Raman resonance conditions and thus the cooling efficiency.

### Results
- **Imaging quality**: By optimizing the parameters, the authors have successfully achieved clear imaging of 87Rb atoms with an exposure time of 1 second, a signal - to - noise ratio of about 13, and are able to resolve the position of individual atoms.
- **Cooling effect**: Through continuous Raman sideband cooling, the atoms are cooled to near the ground state, with an estimated residual temperature of about 1.4 µK and a ground - state occupancy rate of more than 85% in each direction.

In summary, this paper has successfully solved the problem of imaging strongly - coupled atoms in high - bandwidth fiber Fabry - Perot cavities by introducing the repumping fluorescence imaging technique, and has achieved high - quality imaging and efficient cooling through detailed parameter optimization.