Pre-stack Q estimation based on inverse spectral decomposition

Bo Li,Xiaotao Wen,Wenliang Nie,Ziyu Qin,Yilong He

DOI: https://doi.org/10.1016/j.petrol.2021.108775

IF: 5.168

2021-10-01

Journal of Petroleum Science and Engineering

Abstract:<h2 class="section-title u-h3 u-margin-l-top u-margin-xs-bottom">:</h2><p>The quality factor can quantitatively measure the attenuation of seismic waves, and it can compensate for seismic wave amplitude attenuation and correct the phase distortion. The traditional Q extraction method uses the post-stack seismic data to extract the Q-factor. Due to the low-pass filtering effect of the stacked seismic data, the obtained quality factor may be inaccurate. A method of estimating the quality factor using pre-stack common midpoint (CMP) gather data is proposed in this paper. In this method, inversion spectrum decomposition (ISD) and shaping regularization are introduced to obtain the Q-factor. During the process, we obtained the average-Q through inversion and finally obtained the internal-Q by using the average-Q. The numerical simulation and field data application show that the Q obtained using this method can accurately identify the oil-bearing area. Then, the Q is applied to the inverse Q-filter and produces seismic data with a high resolution and a high signal-to-noise ratio.</p>

energy & fuels,engineering, petroleum

What problem does this paper attempt to address?

The problem that this paper attempts to solve is how to estimate the quality factor (Q - factor) more accurately in seismic data processing. Traditional methods usually use post - stack seismic data to extract the Q - factor, but due to the low - pass filtering effect of post - stack data, the obtained quality factor may not be accurate enough. Therefore, this paper proposes a Q - factor estimation method based on pre - stack common mid - point (CMP) gather data. This method obtains the Q - factor by introducing inversion spectral decomposition (ISD) and shaping regularization techniques. Specifically, this method first obtains a high - resolution time - frequency spectrum through ISD, then uses the shaping and regularization techniques to obtain the average Q value of each CMP gather, and finally obtains the interval Q value through an inversion strategy. Through numerical simulation and practical data application, it is proved that this method can accurately identify oil - gas areas and generate seismic data with high resolution and high signal - to - noise ratio in inverse Q - filtering.