Abstract:Several sinter plants in China are still using significant proportions of local magnetite concentrate in the sinter blend based on supply proximity. However the overall trend is that concentrates are being replaced by more cost effective sinter fines. The fine size of concentrates results in additional challenges for sintering. In this study, granulation and packing experiments were conducted to investigate the influence of concentrate addition level on granule structure and green bed properties under a wide range of moisture and hydrated lime dosage levels. Provided sufficient water is added during granulation, the existence of micro-particles including concentrate and hydrated lime favours granule growth and increases the mass ratio of adhering layer to nuclei. However, at the same moisture and hydrated lime content, the introduction of more concentrate decreases the bed voidage remarkably since the thicker and weaker adhering layer deforms during dynamic packing. Compared to the 100% sinter fines base blend, introducing concentrate has a negative effect on bed permeability and therefore sinter productivity. For the 10% and 30% concentrate blends tested, increasing hydrated lime from 0 wt% to 4 wt% could improve the green bed permeability in JPU from 53.0 to 65.8 and 39.4 to 60.8 respectively. Based on the experimental results, a semi-empirical green bed voidage model was improved in two aspects. One is applying a one dimensional packing algorithm to get the ideal porosity of dry coarse particles utilising size distribution data rather than the simple log-normal deviation parameter. The other is to add a probability term considering the deformation of granules only happens to the adhering layer. Combined with the widely accepted population balance granulation model developed by Litster, the improved model can give more accurate predicted voidage values for modeling the sintering process and optimizing actual production from the properties of raw materials and moisture content.

Granulation behaviour of specularite fines in ferrous sinter mixtures

Experimental Investigation on Sintering with High Ratio of Limonite

Strengthening granulation behavior of specularite concentrates based on matching of characteristics of iron ores in sintering process

Optimising method for improving granulation effectiveness of iron ore sintering mixture

Effect of characteristics of fine iron ores on the granulation behavior of concentrate in sintering granulation process

Influence of nature and particle size distribution on granulation of iron ore mixtures used in a sinter strand

Effect of characteristics of coarse iron ores on the granulation behaviour of concentrates in the sintering process

Structural Characteristics of Active Quicklime Flux and Optimization of Quasiparticle Granulation Performance in Thick‐Bed Sintering

Evaluation of Compressive Strength and Shear Strength of the Adhering Layer of Granules in Iron Ore Sintering

Experimental Study On Crushing Strength And Young'S Modulus Of Granules In Iron Ore Sintering Using Taguchi Method

Characteristics and Sintering Mechanisms of Iron Ores with a High Proportion of High-Al2O3 Limonite

Characterization of Granule Structure and Packed Bed Properties of Iron Ore Sinter Feeds That Contain Concentrate

Influence of Binder Dosage on Granule Structure and Packed Bed Properties in Iron Ore Sintering Process

Sintering test research with addition of hematite concentrate

Novel insights into the influence of ferric ion as a surface modifier to enhance the floatability of specularite

Investigation the iron ore fine granulation effects and particle adhesion behavior in a horizontal high-shear granulator

Effect of Ca0 Component on Strength of Pre -Granulated Pellets in Composite Sinter Products

Rheological Studies on Optimizing the Sinter Mix Granulation Mechanism to Sustain Productivity

Synergistic preparation of forsterite‐spinel refractory materials from ferronickel slag and ferrochromium slag

Enhancing Zero-Valent Iron (ZVI) Pulverization During Mechanical Milling: FeSx As Milling Aids

Assessing Stainless Steel Swarf Effect on Limonitic Laterite Sintering Process