Functional Materials Based on Active Carbon and Titanium Dioxide in Fog Seal

Chuan He,Qingyi Xiao,Fangyuan Gong,Yun Yang,Xipeng Ren

DOI: https://doi.org/10.3390/ma13225267

IF: 3.4

2020-11-21

Materials

Abstract:Due to its ability to degrade nitrogen oxides under ultraviolet, titanium dioxide has been applied in asphalt concrete to degrade automobile exhaust in recent years. To highlight the protection of road traffic environmental quality and mitigate automobile exhaust on human health, this study proposes combining titanium dioxide and active carbon into Sand-fog seal to form a pavement coating material with a photocatalytic function. It uses active carbon to reinforce the material’s function, and the coupling agent for modification makes it well dispersed in the Sand-fog seal. The indoor experiments were carried out at 30 °C and relative humidity of 30%. It tested the composite material’s degradation efficiency on nitrogen dioxide in relation to component proportions, coupling agents, and dosages. The study concluded that the optimal photocatalytic efficiency could be achieved when the ratio of active carbon to titanium dioxide is 0.6. After being modified by the titanate coupling agent and through Scanning Electron Microscope tests, it can be seen that materials can be well dispersed into the Sand-fog seal. When the composite material accounts for 10% of the fog seal, it can achieve the optimal photocatalytic efficiency of about 23.9%. The British pendulum tests show it has good skid resistance performance. Half a kilometer of concrete roadway was sprayed with the material coating in Tianjin, China. The photocatalytic experimental road degrades nitrogen oxides better than the original road. The method is feasible for practical implementation.

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

### Problems the Paper Aims to Solve

The paper aims to address the impact of automobile exhaust emissions on environmental quality and human health in urban road traffic. Specifically, the study investigates the combination of titanium dioxide (TiO₂) and activated carbon to create a composite material with photocatalytic functions, and its application in fog seal to enhance the degradation efficiency of nitrogen oxides (NOₓ).

#### Main Objectives:
1. **Optimization of Photocatalytic Performance**: To find the optimal photocatalytic effect by adjusting the ratio of activated carbon to titanium dioxide and adding coupling agents.
2. **Feasibility of Engineering Application**: To verify the application effect of the composite material in actual roads and evaluate its degradation capacity for nitrogen oxides.
3. **Skid Resistance Performance**: To ensure that the composite material not only has good photocatalytic performance but also possesses good anti-skid properties for road surfaces.

#### Overview of Experimental Methods:
- **Indoor Experiments**: Testing the photocatalytic efficiency of different ratios of activated carbon and titanium dioxide under controlled conditions.
- **Selection of Coupling Agents**: Improving the dispersion of the material in the fog seal using four different coupling agents (KH550, KH570, KH792, and TCA).
- **Dose Optimization**: Determining the optimal amount of composite material to be added to the fog seal material.
- **Outdoor Experiments**: Spraying the composite material on a section of concrete road in Tianjin, China, and testing its actual photocatalytic effect.

#### Main Conclusions:
- The optimal photocatalytic efficiency can be achieved when the ratio of activated carbon to titanium dioxide is 0.6.
- The material modified by coupling agents can be well dispersed in the fog seal.
- When the composite material accounts for 10% of the fog seal material, an optimal photocatalytic efficiency of approximately 23.9% can be achieved.
- The British Pendulum Tester results indicate that the material has good anti-skid performance.
- After spraying the material on a half-kilometer section of concrete road in Tianjin, China, experiments proved that its degradation effect on nitrogen oxides is superior to that of the original road.