Abstract:This paper addresses new challenges arising from the emergence of Bluetooth mesh and its rapid adoption in Internet of Things (IoT) and Industrial IoT.One of the main problems associated with Bluetooth mesh is the power consumption of the mesh nodes, since the network needs to be scanned constantly to receive and relay messages. In order to reduce the energy consumption in the nodes where possible, the friendship mechanism is provided as a solution by the Bluetooth mesh specification.The friendship mechanism enables Low Power Nodes (LPNs) to spend most of their lifetime in sleep mode without losing the messages addressed to them. For this purpose, a node that is constantly in scan mode, called friend node (FN), stores these messages, sending them on request. This mechanism works with a stop-and-wait protocol, resulting in inefficient channel utilisation. However, to the best of our knowledge, there are no proposals for the optimisation of this mechanism, likely due to its novelty.This paper studies different approaches for the optimisation of the friendship mechanism: improving the Bearer Layer, improving time synchronization and improving advertising channel utilisation. The results of this study reveal that each of the proposals presents a limitation that makes its final implementation unfeasible, and thus the challenge arises of developing a proposal for its optimisation. Accordingly, this work presents a proposal to optimise the friendship mechanism with Burst Transmissions and Listen Before Transmit (BTLBT), which has been evaluated and validated in real hardware platforms. The results obtained for 4 LPNs show a reduction in the time required to receive the FN messages, as well as a 66.65% reduction in the time required to scan for each message. Finally, a consumption study is presented, where the results show that our proposal achieves a 19.81% improvement in lifetime compared to the standard friendship mechanism.

Optimizing Packet Reception Rates for Low Duty-Cycle BLE Relay Nodes

ACE: A Routing Algorithm Based on Autonomous Channel Scheduling for Bluetooth Mesh Network

BLEdge: Edge-centric Programming for BLE Applications with Multi-Connection Optimization

RT-BLE: Real-time Multi-Connection Scheduling for Bluetooth Low Energy.

A Comprehensive Evaluation of Bluetooth Low Energy Mesh

Towards Efficient BLE Mesh: Design of an Autonomous Network Joining Algorithm

Battery-Friendly Relay Selection Scheme for Prolonging the Lifetimes of Sensor Nodes in the Internet of Things.

Bluetooth Low Energy mesh network for power-limited, robust and reliable IoT services

Reducing the energy consumption of the friendship mechanism in Bluetooth mesh

Batteryless BLE and Light-based IoT Sensor Nodes for Reliable Environmental Sensing

Bluetooth Mesh Analysis, Issues, and Challenges

A Load Balance Routing Algorithm for Medical IoT Based on Link Quality

Latency and Power Consumption in 2.4 GHz IoT Wireless Mesh Nodes: An Experimental Evaluation of Bluetooth Mesh and Wirepas Mesh

Selected Energy Consumption Aspects of Sensor Data Transmission in Distributed Multi-Microcontroller Embedded Systems

SDN On BLE: Controlling Resource Constrained Mesh Networks

Demystifying the Performance of Bluetooth Mesh: Experimental Evaluation and Optimization

Energy efficient link-delay aware data forwarding in low-duty-cycle LoRa mesh-based IoT networks

FloatingBlue: A Delay Tolerant Networks-Enabled Internet of Things Architecture for Remote Areas Combining Data Mules and Low Power Communications

Relay-Enabled Backscatter Communications: Linear Mapping and Resource Allocation

Massive Wireless Energy Transfer with Multiple Power Beacons for very large Internet of Things

Optimum Wirelessly Powered Relaying