Abstract:A brief outline of the development of a three-dimensional primitive equation baroclinic model for computing the internal tides is presented. A series of calculations are performed to examine the internal tide in the shelf edge region off the west coast of Scotland, with the aim of determining the influence upon the internal tide in the region of topographic features, namely large-scale features, such as seamounts, and small-scale features, such as a detailed specification of the shelf slope, which is possible using results from a recent survey rather than topographic data taken from a coarse grid model using depths interpolated from charts. The influence upon the solution of small variations in the density field and seasonal variations is examined. Also, the influence of a well-mixed bottom boundary layer at the base of the shelf slope, produced possibly by cascading of dense water off the shelf during a major wind event, upon the internal tide is also examined. In the calculations described here the model is used in cross-shelf form. A comparison of internal tides computed with and without the inclusion of an offshore seamount shows that internal tides are produced along the sides of the seamount, and can propagate towards the shelf edge, and thereby influence the internal tidal signal in that region. A comparison of internal tides computed using previously available bottom topography extracted from charts with those computed using a detailed topographic data set from a recent survey shows the importance of accurate topography in the shelf edge region for internal tide calculations. Simulations show that the internal tide is influenced by variations in the density field, suggesting that an accurately measured density field is essential for internal tide determination. Calculations also show that if a well-mixed sea bed boundary layer occurs at the bottom of the shelf slope, the internal tide can be reflected by this feature giving rise to significant internal tides in the ocean at larger distances from the shelf edge than in the absence of this water mass. Copyright (C) 1999 John Wiley & Sons, Ltd.

Internal tide generation from non-uniform barotropic body forcing

Internal tides at the coast: energy flux of baroclinic tides propagating into the deep ocean in the presence of supercritical shelf topography

Theoretical Study of the Effect of Topographic Height and Width on Generation of Internal Tides

Superinertial internal tides propagating along the coast: dynamics and energetics revealed through topographic modes

A Numerical Study of Tsunami Wave Impact and Run-Up on Coastal Cliffs Using a CIP-based Model

Internal Tide Generation and Dissipation by Small Periodic Topography in Deep Ocean

Experimental Study of Internal Gravity Waves Generated by Supercritical Topography

Tidal conversion into vertical normal modes by near-critical topography

Study on Internal Waves Generated by Tidal Flow over Critical Topography

Internal Wave Generation by a Combination of Tidal and Steady Currents

Rapid near-inertial wave generation at topography in response to surface wind forcing

Formulation of a three-dimensional shelf edge model and its application to internal tide generation

A higher order time domain rankine panel method for linear and weakly non-linear computation

The Influence of Topographic Features and Density Variations Upon the Internal Tides in Shelf Edge Regions

Experimental Investigation of Tidally-Forced Internal Wave Turbulence at High Reynolds Number

Numerical Studies on the Degeneration of Internal Waves Induced by an Initial Tilted Pycnocline

Turbulence Generation by Tide-Driven Resonant Internal Waves on a Continental Slope

On the Resonant Triad Interaction over Mid-Ocean Ridges

On the Equilibration of Numerical Simulation of Internal Tide: A Case Study Around the Hawaiian Ridge

Regional modeling of internal-tide dynamics around New Caledonia – Part 1: Coherent internal-tide characteristics and sea surface height signature

Coastal-Trapped Waves and Tides at Near-Inertial Frequencies