Information Transmission Through Solids Using Ultrasound Invited Paper
Jafar Saniie,Boyang Wang,Xin Huang
DOI: https://doi.org/10.1109/ultsym.2018.8579702
2018-01-01
Abstract:Ultrasonic signals can be utilized as a viable communication method to transmit information through gas, liquid, and solid channels or a mixed media consisting of a solid interfaced with liquid and/or gas. Underwater communication channels using sound waves cause many challenges, often unforeseen, due to absorption, scattering, refractions, reverberations, multipaths, doppler shifts, temperature, salinity, and acoustic scintillation. Ultrasonic communication through the air is less prone to the environmental challenges that are often encountered in the underwater communications. Ultrasonic communication in solid channels is also adversely affected by absorption, scattering, refractions, reverberations, beam skewing, dispersion, mode conversation, multipaths, and above all these challenges are compounded by the geometrical structure of solids and type of ultrasonic waves. With solid structures many different ultrasonic wave types can be generated including Longitudinal (Compressional), Shear (Transverse), Surface-Rayleigh, Plate Lamb (Symmetrical or Extensional Mode and Asymmetric or Flexural Mode), Plate-Love, and Stoneley (Leaky Rayleigh). The type of waves is governed by the frequency and angle of the incident waves on a solid structure where the quality of the signal for communication is limited by the composition and geometrical shape of the solids. For this study we have developed a testbed platform using the ZYNQ SoC (System-on-Chip) FPGA by Xilinx which offers reconfigurability and high-performance computational capability, high speed signal converters, power amplifiers for excitation of transducers, low noise receiving amplifiers and high frequency ultrasonic transducers for transmitting and receiving information. Theoretically, ASK (amplitude shift keying) or any form of digital modulation can be realized with the system using the concept of the software-defined ultrasonic communications (SDUC). In practice, the received signal is very complex, primarily caused by dispersion, reverberation, and multipath effects. We have examined SDUC system using AM (Amplitude Modulation), OOK (on and off keying), BPSK (Binary Phase Shift Keying), QPSK (quadrature phase shift keying), and OFDM (orthogonal frequency-division multiplexing). This system is tested using differently structured solid channels (such as blocks, plates and pipes); and bitrates and bit rate errors are compared using 2.5 MHz ultrasonic transducers. Furthermore, this paper presents an overview of using EMAT for ultrasonic communications in metal channels.