Contaminant Spot Check and Removal Assay (ContamSPOT) for Mass Spectrometry Analysis

Noah Smeriglio,Haorong Li,Wan Nur Atiqah binti Mazli,Katharine Bendel,Ling Hao

DOI: https://doi.org/10.1101/2024.01.05.574392

2024-01-06

Abstract:Mass spectrometry (MS) analysis is often challenged by contaminations from detergents, salts, and polymers that compromise the data quality and can damage the chromatography and mass spectrometry instruments. However, researchers may not discover contamination issues until after data acquisition. There is no existing contaminant assay that is sensitive enough to detect trace amounts of contaminants from a few microliters of samples prior to MS analysis. To address this crucial need in the field, we developed a sensitive, rapid, and low-cost contaminant spot check and removal assay (ContamSPOT) to detect and quantify trace amounts of contaminants, such as detergents, salts, and other chemicals commonly used in MS sample preparation workflow. Only one microliter of sample was used prior to MS injection to quantify contaminants by ContamSPOT colorimetric or fluorometric assay on a thin layer chromatography (TLC) plate. We also optimized contaminant removal methods to salvage samples with minimal loss when ContamSPOT showed a positive result. ContamSPOT was then successfully applied to evaluate commonly used bottom- up proteomic methods, regarding the effectiveness of removing detergents, peptide recovery, and reproducibility. We expect ContamSPOT to be widely adopted by MS laboratories as a last-step quality checkpoint prior to MS injection. ContamSPOT can also provide a unique readout of sample cleanness for developing and evaluating MS-based sample preparation methods. We provided a practical decision tree and a step-by-step protocol with a troubleshooting guide to facilitate the use of ContamSPOT by other researchers.

Biochemistry

What problem does this paper attempt to address?

This paper mainly focuses on the detection and removal of contaminants in samples in mass spectrometry (MS) analysis. Existing methods often identify contamination issues only after data acquisition, and the existing contamination detection methods are not sensitive enough for trace compounds. Therefore, researchers have developed a rapid and low-cost contamination detection and removal technology called ContamSPOT. This technology allows for quantitative detection of chemicals such as detergents, salts, and other common chemicals in the MS sample preparation process using colorimetry or fluorescence on a chromatographic plate with just one microliter of sample before MS analysis. In addition, they have optimized the method for removing contaminants to minimize sample loss. ContamSPOT has been successfully applied to evaluate common protein sample preparation methods, especially in terms of membrane protein or peptide recovery and reproducibility. The paper provides practical decision trees and step-by-step operating instructions for other researchers to use ContamSPOT in experiments and make decisions based on the results. This technology is expected to be widely used as a quality checkpoint before MS injection in MS laboratories and provide a unique sample cleanliness index for the development and evaluation of MS sample preparation methods.