Abstract:The complexity of automobile powertrains continues to increase, leading to increased development time and effort. One method to address this challenge is to shift vehicle calibration and testing tasks to simulations with Engine-in-the-Loop (EiL) test setups. This increases the efficiency of the development process through high flexibility, low prototype costs, an early starting point, and a high degree of automation. EiL emulates the dynamic interactions between the internal combustion engine and other powertrain components by closed-loop coupling to real-time simulation models. The coupling quality strongly depends on the interface properties, the hardware layout, and the control functionality of the dynamometer test bench. This paper analyzes an existing test bench and presents the impact of altered test bench parameters on different EiL quality aspects. Thereto, the setup is analyzed and a Simulink based grey box test bench model is derived. The latter is parametrized with a full factorial approach in comparison to real test bench measurements. The test bench model is then used for simulative investigations considering different test bench parameters: Two different use cases of Model-in-the-Loop (MiL) supported EiL are investigated. First, a simulative improvement of the test bench control quality by altering the PI based dyno speed controller parameters is investigated. The virtually calibrated controller parameters are applied to the real EiL system and compared to vehicle measurements. Second, sensitivity studies are shown with respect to dynamometer inertia and system dead time in terms of control quality and energy. As a major outcome, a compromise of control accuracy and stability for different speed controller parameters, dyno inertia, and system dead time is shown. Furthermore, it is demonstrated that EiL has only a small deviation in terms of energy compared to a full vehicle, making it a valid approach when considering CO 2 emissions.

Low Cost, Educational Internal Combustion Engine Electronic Control Unit Hardware-in-the-Loop Test Systems

Development of the Control and Acquisition System for a Natural-Gas Spark-Ignition Engine Test Bench

The Development of A Real-Time Hardware-in-the-Loop Test Bench for Hybrid Electric Vehicles Based on Multi-Thread Technology

Hardware-in-loop Simulation of a Common Rail Turbocharged Diesel Engine ECU

Research on the Dynamic Model and Ecu Hil Simulation System of Electronic-Controlled Engine

The Hardware Design of Hardware-in-Loop Simulation System of Diesel Engine High Pressure Common-Rail ECU Based on CAN Bus

Development of a New Hardware-in-loop Simulation Platform for GD-1 Diesel Engine Based on CAN and Multithread Technologies

Design of Hardware-in-the-loop simulation system for diesel

Hardware-in-the-loop Real-Time Platform for More Electric Aircraft

A Realistic Simulation Testbed of A Turbocharged Spark-Ignited Engine System: A Platform for the Evaluation of Fault Diagnosis Algorithms and Strategies

Design and research on engine emulation system of HEV power train hardware-in-the-loop simulation platform

The Development of Hardware-in-the-loop Simulation System of Hybrid Vehicle

An Application of Real-Time Engine Model in HILS Simulation and Testing Platform Based on SIMULINK

Towards a Powerful Hardware-in-the-Loop System for Virtual Calibration of an Off-Road Diesel Engine

Development of Real-time Simulation System for Gasoline Engine Based on Engine Model and Road Test Data

Development of Engine Combustion Analysis System on Virtual Instrument

Real-time Control Oriented HCCI Engine Cycle-to-cycle Dynamic Modelling

Application of circuit simulation in Hardware design for Electronic Control Unit of Compressed Natural Gas engine

Development of a Hardware-in-the-loop Simulation System for Hybrid Electric Vehicle Performance Test

Engine-in-the-Loop in practical application: A sensitivity study toward the influence of test bench parameters

Hardware-in-loop Approach Based on Improved Endyna Model to Gasoline Engine Control