Abstract:The topic of VSG grid voltage fault ride through has drawn increasing attention as virtual synchronous generator (VSG) technology has been widely applied in the field of renewable energy power generation. Due to the delay of the reactive power compensation device after the low-voltage fault recovery, the high-voltage fault will happen immediately after the grid's low-voltage fault is resolved. This phenomenon is known as low and high voltage cascading faults. There is not enough research on this specific voltage fault right now. For specific investigation, the low and high voltage cascading faults in this paper are separated into low-voltage fault stages and high-voltage fault stages. The equal area criterion (EAC) is used to analyze the specific process at the low-voltage fault stage. In addition, the dynamic damping control (DDC) is utilized to resolve the problem of low-voltage fault stability. Under low voltage fault, the phase portrait studies the single-period stability with an equilibrium point in a single-period and the multi-period stability without an equilibrium point in a single-period, respectively. Using a phase portrait to analyze system performance during a high voltage fault, and a virtual capacitor feedback control (VCFC) is offered to effectively reduce active power overshoot due to high voltage fault. The EAC is used to analyze the specific process of the high voltage stage, it is concluded that there is always an equilibrium point in the high-voltage fault where IGBT limitations are ignored. Finally, the correctness and feasibility of the theory are verified by simulation, and the specific analysis results are given.

Transient Stability Assessment for Current Constrained and Unconstrained Fault Ride-Through in Virtual Oscillator Controlled Converters

A Unified Fault Ride Through Technique for Virtual Oscillator based Grid Forming Controllers

Transient Voltage Stability Analysis and Enhancement of Grid-Following Converters Considering Current Limitation

Transient Stability Analysis and Control Design of Droop-Controlled Voltage Source Converters Considering Current Limitation.

Unified Virtual Oscillator Control for Grid-Forming and Grid-Following Converters

Control Method for Fault Ride-through of DFIG-based Wind Turbines Applied to Weak Grids

Control Methods to Improve Virtual Power Angle Transient Stability of Droop-Controlled Inverters

Comparative Transient Stability Assessment of Droop and Dispatchable Virtual Oscillator Controlled Grid-Connected Inverters

Design-Oriented Analysis and Transient Stability Enhancement Control for a Virtual Synchronous Generator

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

A New Virtual Oscillator based Grid-forming Controller with Decoupled Control Over Individual Phases and Improved Performance of Unbalanced Fault Ride-through

Transient Stability Enhancement of Current Limited-GFM Inverters Based on Varying Virtual Impedance

Transient Stability Analysis for Grid-tied VSG Considering High-Order Nonlinear Interactions Between Active and Reactive Power Control Loops

Transient Stability Emergency Control for AC/DC Grids Considering Successive Commutation Failures

Current-Constrained Power-Angle Characterization Method for Transient Stability Analysis of Grid-Forming Voltage Source Converters

A Method to Improve Both Frequency Stability and Transient Stability of Virtual Synchronous Generators during Grid Faults

Transient Stability Analysis for a Multi-VSC Parallel System Based on the CFND Method

Improved transient stability of virtual synchronous generators for grid voltage cascading faults

Transient Stability Analysis and Improvement for the Grid-Connected VSC System with Multi-Limiters

Transient Synchronous Stability Analysis of Grid-Following Converter Considering Outer-Loop Control with Current Limiting

A Model Predictive Approach for Enhancing Transient Stability of Grid-Forming Converters