The DeRisk database: Extreme design waves for offshore wind turbines
Fabio Pierella,Ole Lindberg,Henrik Bredmose,Harry B. Bingham,Robert W. Read,Allan P. Engsig-Karup
DOI: https://doi.org/10.1016/j.marstruc.2021.103046
IF: 4.5
2021-11-01
Marine Structures
Abstract:The estimation of extreme loads from waves is an essential part of the design of offshore wind turbines. Standard design codes suggest either to use simplified methodologies based on regular waves, or to perform fully-nonlinear computations. The former may not provide an accurate representation of the real extreme waves, while the latter is too computationally intensive for fast design iterations. Here, we address these limitations by using the fully-nonlinear solver OceanWave3D to establish the DeRisk database, a large dataset of extreme wave kinematics in a two-dimensional domain. From the database, which is open and freely available, a designer can easily extract fully-nonlinear wave kinematics for a wave condition and water depth of interest by identifying a suitable computation in the database and, if needed, by Froude-scaling the kinematics. This will ultimately enable quicker estimations of nonlinear wave loads, speeding up design evaluations. The database sea states cover a range of nondimensional depth of about h∗∈[3.0⋅10−3,6.5⋅10−2] and of nondimensional significant wave height of HS∗∈[1.0⋅10−3,8.0⋅10−3], where h∗=h/(gTP2)[−] and HS∗=HS/(gTP2)[−].The fully-nonlinear solver is validated against the DeRisk model-scale experiments, where a number of long-crested sea state realizations are generated at two different water depths, 33.0[m] and 20.0[m], and the induced force on a stiff monopile with a diameter of D=7.0[m] is measured.Comparison with the experiments shows that the database predicts maximum crest elevations at both depths very accurately. Predictions of the in-line force, obtained by application of the Rainey slender body force model with the database wave kinematics, are accurate for milder storms. However, for stronger storms, where slamming loads from breaking waves dominate, the force computations from the database kinematics provide slightly nonconservative force estimates compared with the standard methodologies such as the embedded stream function and the WiFi JIP model. This discrepancy is mainly due to the lack of a slamming load model in the applied force model. A procedure to add slamming loads to OceanWave3D and to the DeRisk database is currently being developed.
engineering, civil, marine