Electrochemical syntheses and characterization of some polydyes and their application for the simultaneous determination of ascorbic acid and uric acid

DOI: https://doi.org/10.1007/s10800-024-02126-8

IF: 2.925

2024-05-14

Journal of Applied Electrochemistry

Abstract:Monomers: gentian violet (GV), brilliant green (BG), aniline, and methyl violet (MV), as well as their copolymers, were electropolymerized and used to modify glassy carbon electrode (GCE) by enhancing the sensitivity of the electrode. This is due to their special characteristics of sensing ability of the electropolymerized polymers. The electropolymerization and characterization of these monomers and their copolymers were done using cyclic voltammetry (CV) on GCE as a working electrode against Ag/AgCl reference electrode and platinum wire as the counter electrode. The copolymers showed higher current peaks than their corresponding homopolymers. The electrochemical characterization of these polymers and copolymers was studied by scan rate effect each between 10 and 300 mV/s and pH effect between 1.56 and 5.30. After being modified by the copolymers: poly(BG-GV) and poly(BG-MV), the modified GCE showed good results in resolving the peaks of ascorbic acid and uric acid which otherwise showed an overlapped broad peak on bare GCE. The CV in bare GCE was scanned at different scan rates of 4 mM K 3 [Fe(CN) 6 ] in 1 M KNO 3 solution. The square root of scan rate dependence of peak current was plotted and the Randles–Sevcik equation was applied to determine the diffusion coefficient of Fe(CN) 6 3− ion and which was 1.13 × 10 –14 cm 2 /s. This was used to determine the area of the modified electrode after running the CV of 4 mM K 3 [Fe(CN) 6 ] in 1 M KNO 3 at different scan rates. Therefore, the electrochemical polymerization of organic dye polymers was able to increase the sensitivity of the electrode by increasing its area.

electrochemistry