Abstract:The recently developed tough and self-healing hydrogels, containing a large number of physical bonds, have found widespread applications in bioengineering and soft electronics. Owing to the sophisticated physical interactions and organization, these hydrogels often demonstrate structural heterogeneities, which strongly influence their mechanical performances. Using poly(N,N-dimethyl acrylamide-co-methacrylic acid) hydrogels (P(DMAA-co-MAAc)) with dynamic hydrogen bonds (H-bonds) as a model system, the structural characterization has been carried out in this study using small-angle X-ray scattering (SAXS) and small-angle neutron scattering (SANS) analyses, along with exploring the influence of the structure on the mechanical properties. By systematically tuning the polymer composition, including the monomer fraction and chemical cross-linking density, two different hydrogel regions with distinct mechanical properties were observed: the swollen regions and shrunk regions. The former was mechanically weak, whereas the latter exhibited a tough behavior. Both types of hydrogels were noted to be highly heterogeneous, which results from the nanoscale spatial polymer concentration fluctuations at ∼100 nm scale. Combined with the contrast variation utilizing SANS, the structure parameters, including the polymer volume fraction of the dense and sparse regions, volume fraction occupied in the space, and average correlation length of the long-range and short-range heterogeneous structures, were explored using a scaling model based on a two-phase system composed of the densely and sparsely cross-linked regions. Using in situ SAXS, the microscopic deformation of the tough and shrunk hydrogels was noted to follow the affine deformation, while a significantly non-affine deformation was observed in the swollen hydrogels, which might have led to the different mechanical performances of these materials.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.macromol.1c01064.Swelling volume ratio of hydrogels 0.14-0.2% during the drying–swelling cycle (Figure S1); FT-IR spectra of PDMAA, PMAAc, and P(DMAA-co-MAAc) and temperature dependence of FT-IR spectrum of P(DMAA-co-MAAc) (Figure S2); semi-empirical quantum chemical calculations for revealing the conformation features and their interaction in water (Figure S3); tensile stress–strain curves of P(DMAA-co-MAAc) hydrogels f-0.1% with various f values (0.12, 0.13, and 0.15) and P(DMAA-co-MAAc) hydrogels 0.14-x with various x values (0.05, 0.1, and 0.15%) (Figure S4); 1D scattering intensity as a function of the scattering vector q under various stretch ratios for the hydrogels f-0.1% with the molar fraction of DMAA varying from 0.12 to 0.15 and hydrogels 0.14-x with the chemical cross-linking density ranging from 0.05 to 0.15% (Figures S5 and S6); stretch-induced structure evolution of the swollen hydrogel 0.14-0 (Figure S7); tensile stress–strain curve of hydrogel 0.14-1% and the corresponding Mooney–Rivlin plot (Figure S8); and structural parameters of the swollen and shrunk hydrogels (Table S1) (PDF)This article has not yet been cited by other publications.

Molecular mechanism of abnormally large nonsoftening deformation in a tough hydrogel

Strong and Ultra-Tough Supramolecular Hydrogel Enabled by Strain-Induced Microphase Separation

A Constitutive Model for Mechanical Behaviors of Novel Double Network Hydrogels with Mechanophores

Sculpting Mechanical Properties of Hydrogels by Patterning Seamlessly Interlocked Stiff Skeleton

Investigating Temperature‐Dependent Microscopic Deformation in Tough and Self‐healing Hydrogel Using Time‐Resolved USAXS

Time-Dependent Constitutive Behaviors of a Dynamically Crosslinked Glycerogel Governed by Bond Kinetics and Chain Diffusion

Structure Optimization and Mechanical Model for Microgel-Reinforced Hydrogels with High Strength and Toughness

Control Superstructure of Rigid Polyelectrolytes in Oppositely Charged Hydrogels Via Programmed Internal Stress

Strong and Tough Fibrous Hydrogels Reinforced by Multiscale Hierarchical Structures with Multimechanisms

Ultrastiff and Tough Supramolecular Hydrogels with a Dense and Robust Hydrogen Bond Network

Fracture, fatigue, and friction of polymers in which entanglements greatly outnumber cross-links

Macromolecule conformational shaping for extreme mechanical programming of polymorphic hydrogel fibers

Constitutive Behaviors of Tough Physical Hydrogels with Dynamic Metal-Coordinated Bonds

Strain stiffening universality in composite hydrogels and soft tissues

Strong, tough and anisotropic bioinspired hydrogels

Hydrophilicity‐Hydrophobicity Transformation, Thermoresponsive Morphomechanics, and Crack Multifurcation Revealed by AIEgens in Mechanically Strong Hydrogels

Tough Hydrogels with Dynamic H-Bonds: Structural Heterogeneities and Mechanical Performances

Multiscale Energy Dissipation Mechanism in Tough and Self-Healing Hydrogels.

Fibrous Hydrogels under Multi‐Axial Deformation: Persistence Length as the Main Determinant of Compression Softening

A strategy for tough and fatigue-resistant hydrogels via loose cross-linking and dense dehydration-induced entanglements

Tough hydrogels with rapid self-reinforcement