Fiber Laser Frequency Comb Based on a 45° Tilted Fiber Grating(Invited)
Huang Zinan,Huang Qianqian,Tian Haochen,Yan Zhijun,Zou Meng,Sun Jinghua,Gu Chenglin,Wang Kai,Xu Zishuo,Li Weixi,Dai Lilong,Liang Xindong,Mou Chengbo
DOI: https://doi.org/10.3788/lop232492
2024-01-01
Laser & Optoelectronics Progress
Abstract:A highly reliable and stable erbium-doped mode-locked fiber laser was constructed using a 45 degrees-tilted fiber grating (45 degrees-TFG) as a fiber polarizer. Based on this, precise signal stabilization of the repetition frequency f(rep) and carrier-envelope offset frequency f(ceo) was achieved. When the pump power is 228 mW, the mode-locked laser oscillator based on a 45 degrees-TFG can achieve an ultra-short pulse output of 3 dB with a spectral bandwidth of 60.4 nm and a pulse width of 68 fs. The root mean square stability of the power reaches 0.033% within 12 hours, and it can maintain a good stretched mode-locked state over a large pump range. After self-built chirped pulse amplification, super-continuum spectrum generation, and f - 2f self-reference beat interference optical path, f(ceo) signal with a signal-to-noise ratio of 32 dB was obtained. Finally, by building an active feedback control circuit based on a phase-locked loop, the f(rep) and f(ceo) signals were traced back to a GPS time-frequency system, and the frequency instability of the f(rep) and f(ceo) signals was measured to be 2.38x10(-12) and 6.41x10(-16) within an average time of 1 second. This is the first implementation of a fiber laser frequency comb based on a 45 degrees-TFG, indicating the potential of a 45 degrees-TFG based mode-locked fiber laser in practical applications.