Abstract:Origin of Zero Order Kinetics Zero-order kinetics is always an artifact of the conditions under which the reaction is carried out. For this reason, reactions that follow zero-order kinetics are often referred to as pseudo-zero-order reactions. Clearly, a zero-order process cannot continue after a reactant has been exhausted. Just before this point is reached, the reaction will revert to another rate law instead of falling directly to zero as depicted at the upper left. There are two general conditions that can give rise to zero-order rates: 1. Only a small fraction of the reactant molecules are in a location or state in which they are able to react, and this fraction is continually replenished from the larger pool. 2. When two or more reactants are involved, the concentrations of some are much greater than those of others This situation commonly occurs when a reaction is catalyzed by attachment to a solid surface (heterogeneous catalysis) or to an enzyme. Example 1: Decomposition of Nitrous Oxide Nitrous oxide will decompose exothermically into nitrogen and oxygen, at a temperature of approximately 575 °C \[\ce{2N_2O ->[\Delta, \,Ni] 2N_2(g) + O_2(g)}\] This reaction in the presence of a hot platinum wire (which acts as a catalyst) is zero-order, but it follows more conventional second order kinetics when carried out entirely in the gas phase. \[\ce{2N_2O -> 2N_2(g) + O_2(g)}\] In this case, the \(N_2O\) molecules that react are limited to those that have attached themselves to the surface of the solid catalyst. Once all of the sites on the limited surface of the catalyst have been occupied, additional gas-phase molecules must wait until the decomposition of one of the adsorbed molecules frees up a surface site. Enzyme-catalyzed reactions in organisms begin with the attachment of the substrate to the active site on the enzyme, leading to the formation of an enzyme-substrate complex. If the number of enzyme molecules is limited in relation to substrate molecules, then the reaction may appear to be zero-order. This is most often seen when two or more reactants are involved. Thus if the reaction \[ A + B \rightarrow \text{products} \tag{1}\] is first-order in both reactants so that

AN EASILY DEMONSTRATED ZERO-ORDER REACTION IN SOLUTION

Zero-Order Reactions Zero-Order Reactions

Origin of Zero Order Kinetics

DISCUSSION OF ZERO-ORDER REACTION MULTIPLICITY

The Finkelstein Reaction: Quantitative Reaction Kinetics of an SN2 Reaction Using Nonaqueous Conductivity

Smoluchowski Reaction Kinetics for Reactions of Any Order

The zero length column technique to measure adsorption equilibrium and kinetics: lessons learnt from 30 years of experience

Revisiting Textbook Azide-Clock Reactions: A "Propeller-Crawling" Mechanism Explains Differences in Rates

Explicit solution of the reversible isomerization followed by zeroth-order kinetics

Homogeneous Equilibrium in Solutions with Limited Solubility of Components

Reaction Acceleration Promoted by Partial Solvation at the Gas/Solution Interface

A General Fitting Function to Estimate Apparent Reaction Orders of Kinetic Profiles

Universal limiting behaviour of reaction-diffusion systems with conservation laws

Reaction Kinetics in Aqueous Surfactant Solutions

Calorimetric determination of rate constants and enthalpy changes for zero-order reactions.

Time evolution of a small reactive system

Diffusion Controlled Reactions, Fluctuation Dominated Kinetics, and Living Cell Biochemistry

HALF-LIFE TIME METHOD FOR SIMPLE ORDER REACTION

The Effect of Zero-Point Energy in Simulating Organic Reactions with Post-Transition State Bifurcation

Reactivity of Zerovalent Metals in Aquatic Media: Effects of Organic Surface Coatings

Ultrafast chemical kinetics: Elementary chemical act