Abstract:Abstract We combine steady-state measurements of relative permeability with pore-scale imaging to estimate local capillary pressure. High-resolution three-dimensional X-ray tomography enables the pore structure and fluid distribution to be quantified at reservoir temperatures and pressures with a resolution of a few microns. Two phases are injected through small cylindrical samples at a series of fractional flows until the pressure differential across the core is constant. Then high-quality images are acquired from which saturation is calculated, using differential imaging to quantify the phase distributions in micro-porosity which cannot be explicitly resolved. The relative permeability is obtained from the pressure drop and fractional flow, as in conventional measurements. The curvature of the fluid/fluid interfaces in the larger pore spaces is found, then from the Young-Laplace equation, the capillary pressure is calculated. In addition, the sequence of images of fluid distribution captures the displacement process. Observed gradients in capillary pressure – the capillary end effect – can be accounted for analytically in the calculation of relative permeability. We illustrate our approach with three examples of increasing complexity. First, we compare the measured relative permeability and capillary pressure for Bentheimer sandstone, both for a clean sample and a mixed-wet core that had been aged in reservoir crude oil after centrifugation. We characterize the distribution of contact angles to demonstrate that the mixed-wet sample has a wide range of angle centred, approximately, on 90°. We then study a water-wet micro-porous carbonate to illustrate the impact of sub-resolution porosity on the flow behaviour: here oil, as the non-wetting phase, is present in both the macro-pores and micro-porosity. Finally, we present results for a mixed-wet reservoir carbonate. We show that the oil/water interfaces in the mixed-wet samples are saddle-shaped with two opposite, but almost equal, curvatures in orthogonal directions. The mean curvature, which determines the capillary pressure, is low, but the shape of the interfaces ensures, topologically, well-connected phases, which helps to explain the favourable oil recovery obtained in these cases. We suggest that the combination of imaging and flow experiments – which we call iSCAL – represents a compelling development in special core analysis. This methodology provides the data traditionally acquired in SCAL studies, but with insight into displacement processes, rigorous quality control, and flexibility over sample selection, while generating detailed datasets for the calibration and validation of numerical pore-scale flow models.

Integrating transient pressure and flow data for determination of hydraulic permeability and specific storage of a shale sample: Experimental tests and sensitivity analysis

Constant head-transient method using pressure and flow data for determining permeability and specific storage of tight rocks

Laboratorial Study on Non-Darcy Seepage in Xiaoshan Clay

Transverse permeability measurements of gas shales under replicated in-situ flow conditions: Mathematical modeling and laboratory testing

A critical analysis of shale laboratory permeability evolution data

iSCAL for Complete Rock Characterization: Using Pore-Scale Imaging to Determine Relative Permeability and Capillary Pressure

Imaging and Measurement of Pore‐Scale Interfacial Curvature to Determine Capillary Pressure Simultaneously with Relative Permeability

Investigation of Shale Permeability Evolution considering Bivalued Effective Stress Coefficients for CO2 Injection

An efficient laboratory method to measure the combined effects of Knudsen diffusion and mechanical deformation on shale permeability

Pore-Scale Simulation and Sensitivity Analysis of Apparent Gas Permeability in Shale Matrix

Fast permeability measurements of tight and sorptive gas reservoirs using a radial-flow transient technique

Klinkenberg Slippage Effect in the Permeability Computations of Shale Gas by the Pore-scale Simulations

A Dynamic Permeability Model in Shale Matrix after Hydraulic Fracturing: Considering Mineral and Pore Size Distribution, Dynamic Gas Entrapment and Variation in Poromechanics

Simultaneous determination of relative permeability and capillary pressure from an unsteady-state core flooding experiment?

Permeability investigation and hydrate migration of hydrate–bearing silty sands and silt

An Apparent Permeability Model in Organic Shales: Coupling Multiple Flow Mechanisms and Factors

Research on an effective permeability prediction method for shale reservoirs based on imbibition experiments

A simplified transient technique for porosity and permeability determination in tight formations: Numerical simulation and experimental validation

A Radial Differential Pressure Decay Method with Micro-Plug Samples for Determining the Apparent Permeability of Shale Matrix

Characterization of Flow Parameters in Shale Nano-Porous Media Using Pore Network Model: A Field Example from Shale Oil Reservoir in Songliao Basin, China

Experimental investigation on low-velocity seepage characteristics and influencing factors in a shale oil reservoir