Abstract:This paper presents a highly sensitive microwave sensor for dielectric sensing. One of the main disadvantages of microwave resonant-based sensors is cross-sensitivity originated by time-dependent uncontrolled environmental factors such as temperature that affect the material under test (MUT) behavior, leading to undesirable frequency shifts and, hence, lower accuracy. However, this work eliminates the unwanted errors using the differential measurement technique by comparing two transmission resonance frequencies during a unit test setup to measure the permittivity of MUT over time. The proposed structure comprises a spiral resonator with an extended horizontal microstrip line (EH-ML) coupled to a microstrip transmission line (MTL). Creating EH-ML within the structure comprises two primary contributions: enhanced sensitivity resulting from stronger fringing fields generated by increasing the effective area and improved resolution due to higher resonance frequencies caused by a lower total capacitive coupling effect. The proposed sensor is fabricated and tested using MUTs with a permittivity of less than 80 to verify the performance. In this regard, a frequency detection resolution (FDR) of 44MHz and a sensitivity of 0.85% are achieved at a maximum permittivity of 78.3. The results of theoretical analysis, simulation, and measurement are in relatively good agreement. Consequently, the proposed highly sensitive microwave sensor offers significant advantages, such as low complexity in design and fabrication. It also offers high resolution and precision in a wide range of permittivity, which can be an attractive candidate for dielectric sensing in health, chemical and agriculture applications.

Microwave Sensor for Detection of Solid Material Permittivity in Single/Multilayer Samples With High Quality Factor

Microwave Sensor for Detection of Solid Material Permittivity in Single/Multilayer Samples With High Quality Factor

Simultaneous Measurement of Thickness and Permittivity Using Microwave Resonator‐based Planar Sensor

Highly Sensitive Differential Microwave Sensor Using Enhanced Spiral Resonators for Precision Permittivity Measurement

Microwave Sensor Loaded With Complementary Curved Ring Resonator for Material Permittivity Detection

Dual-Band Independent Permittivity Sensor Using Single-Port With a Pair of U-Shaped Structures for Solid Material Detection

Dual-sensing and dual-frequency microwave SRR sensor for liquid samples permittivity detection

High-Accuracy Complex Permittivity Characterization of Solid Materials Using Parallel Interdigital Capacitor- Based Planar Microwave Sensor

A Broadband Sensor for Permittivity Measurement of Solid, Crystal Grain and Powder Dielectrics in Microwave Range

A Frequency Synthesizer Based Microwave Permittivity Sensor Using CMRC Structure.

High-Sensitivity Sensor Loaded with Coupled Complementary Spiral Resonators for Simultaneous Permittivity and Thickness Measurement of Solid Dielectric Sheet

A Portable Microwave Interferometry Sensor for Permittivity Detection Based on CCMRC.

Interdigitated Planar Microwave Sensor for Characterizing Single/Multilayers Magnetodielectric Material

High-Sensitivity Accurate Characterization of Complex Permittivity Using Inter-digital Capacitor-Based Planar Microwave Sensor

Novel Microwave Sensors Based on Split Ring Resonators for Measuring Permittivity

High Q-Factor Compact Permittivity Sensor Based on Coupled SRR-ELC Metamaterial Element and Metasurfaces Shield

Design and Optimization of Microwave Sensor for the Non-Contact Measurement of Pure Dielectric Materials

Enhanced accuracy and high sensitivity in dielectric characterization through a compact and miniaturized metamaterial inspired microwave sensor

High-Q Sensor Based on Symmetrical Split Ring Resonator With Spurlines for Solids Material Detection