Abstract:The ATLAS detector is installed in its experimental cavern at Point 1 of the CERN Large Hadron Collider. During Run 2 of the LHC, a luminosity of $\mathcal{L}=2\times 10^{34}\mathrm{cm}^{-2}\mathrm{s}^{-1}$ was routinely achieved at the start of fills, twice the design luminosity. For Run 3, accelerator improvements, notably luminosity levelling, allow sustained running at an instantaneous luminosity of $\mathcal{L}=2\times 10^{34}\mathrm{cm}^{-2}\mathrm{s}^{-1}$, with an average of up to 60 interactions per bunch crossing. The ATLAS detector has been upgraded to recover Run 1 single-lepton trigger thresholds while operating comfortably under Run 3 sustained pileup conditions. A fourth pixel layer 3.3 cm from the beam axis was added before Run 2 to improve vertex reconstruction and $b$-tagging performance. New Liquid Argon Calorimeter digital trigger electronics, with corresponding upgrades to the Trigger and Data Acquisition system, take advantage of a factor of 10 finer granularity to improve triggering on electrons, photons, taus, and hadronic signatures through increased pileup rejection. The inner muon endcap wheels were replaced by New Small Wheels with Micromegas and small-strip Thin Gap Chamber detectors, providing both precision tracking and Level-1 Muon trigger functionality. Tile Calorimeter scintillation counters were added to improve electron energy resolution and background rejection. Upgrades to Minimum Bias Trigger Scintillators and Forward Detectors improve luminosity monitoring and enable total proton-proton cross section, diffractive physics, and heavy ion measurements. These upgrades are all compatible with operation in the much harsher environment anticipated after the High-Luminosity upgrade of the LHC and are the first steps towards preparing ATLAS for the High-Luminosity upgrade of the LHC. This paper describes the Run 3 configuration of the ATLAS detector.

Upgrade of ATLAS hadronic Tile Calorimeter for the High Luminosity LHC

Design of the Compact Processing Module for the ATLAS Tile Calorimeter

ATLAS Tile Calorimeter Calibration and Monitoring Systems

Operation and performance of the ATLAS tile calorimeter in LHC Run 2

Optics robustness of the ATLAS Tile Calorimeter

Operation and performance of the ATLAS Tile Calorimeter in Run 1

Operational experience and evolution of the ATLAS Tile Hadronic Calorimeter Read-Out Drivers

Long term aging studies of the new PMTs used for the HL-LHC ATLAS hadron calorimeter upgrade

Tile Computer-on-Module for the ATLAS Tile Calorimeter Phase-II upgrades

On-beam system test of the new readout electronics for the CMS Electromagnetic Calorimeter upgrade

The upgrade of the CMS electromagnetic calorimeter for HL-LHC

A monitoring and control test bench for assessing the upgraded low voltage power supplies for the ATLAS Tile Calorimeter Phase-II Upgrade front-end electronics

Design and Evaluation of the LAr Trigger Digitizer Board in the ATLAS Phase-I Upgrade

Realization and Test of the Engineering Prototype of the CALICE Tile Hadron Calorimeter

The ATLAS Experiment at the CERN Large Hadron Collider: A Description of the Detector Configuration for Run 3

The Clock and Control System for the ATLAS Liquid Argon Calorimeter Phase-I Upgrade

The CMS High-Granularity Calorimeter for Operation at the High-Luminosity LHC

Current and future challenges when operating the ATLAS Liquid Argon Calorimeter

Status of the CALICE analog calorimeter technological prototypes

Upgrade of the Inner Tracking System of ALICE

Prototype Tests for a Highly Granular Scintillator-Based Hadronic Calorimeter