Abstract:Abstract The research and development of new Solid Oxide Fuel Cell cathode materials is an area of intense activity. The kinetic coefficients describing the O 2 -reduction mechanism are the O-ion diffusion ( D chem ) and the O-surface exchange coefficients ( k chem ). These parameters are strongly dependent on the nature of the material, both on its bulk and surface atomic and electronic structures. This review discusses the method for obtaining the kinetic coefficients through the combination of electrochemical impedance spectroscopy with focused ion-beam 3D tomography measurements on porous electrodes (3DT-EIS). The data, together with oxygen non-stoichiometry thermodynamic data, is analysed using the Adler-Lane-Steele model for macro-homogeneous porous electrodes. The results for different families of oxides are compared: single- and double-layered perovskites with O-vacancies defects, based on La-Sr cobalt ferrites (La 0.6 Sr 0.4 Co 1-x Fe x O 3- δ , x = 0.2 and 0.8) and La/Pr-Ba cobaltites (La 0.5-x Pr x Ba 0.5 CoO 3- δ , x = 0.0, 0.2 and 0.5), as well as Ruddlesden-Popper nickelates (Nd 2 NiO 4 + δ ) with O-interstitial defects. The analysis of the evolution of molar surface exchange rates with oxygen partial pressure provides information about the mechanisms limiting the O 2 -surface reaction, which generally is dissociative adsorption or dissociation-limited . At 700 °C in air, the La-Ba cobaltite structures, La 0.5-x Pr x Ba 0.5 CoO 3- δ , feature the most active surfaces ( k chem ≃0.5–1 10 −2 cm.s −1 ), followed by the nickelate Nd 2 NiO 4 + δ and the La-Sr cobalt ferrites, with k chem ≃1–5 10 −5 cm.s −1 . The diffusion coefficients D chem are higher for cubic perovskites than for the layered ones. For La 0.6 Sr 0.4 Co 0.8 Fe 0.2 O 3- δ and La 0.6 Sr 0.4 Co 0.2 Fe 0.8 O 3- δ , D chem is 2.6 10 −6 cm 2 .s −1 and 5.4 10 −7 cm 2 .s −1 , respectively. These values are comparable to D chem = 1.2 10 −6 cm 2 .s −1 , observed for La 0.5 Ba 0.5 CoO 3- δ . The layered structure drastically reduces the O-ion bulk diffusion, e.g. D chem = 1.3 10 −8 cm 2 .s −1 for the Pr 0.5 Ba 0.5 CoO 3- δ double perovskite and D chem ≃2 10 −7 cm 2 .s −1 for Nd 2 NiO 4 + δ . Finally, the analysis of the time evolution of the electrodes shows that the surface cation segregation affects both the O-ion bulk diffusion and the surface exchange rates.

The role of input gas species to the cathode in the oxygen-ion conducting and proton conducting solid oxide fuel cells and their applications: Comparative 4E analysis

Anode-Oxidizing Critical Operating Conditions of Large Planar Solid Oxide Fuel Cell

Quantitative Investigation of Oxygen Transport in Proton Exchange Membrane Fuel Cell: Considering Cross-Flow

Comparative Performance Investigation of Different Gas Flow Configurations for a Planar Solid Oxide Electrolyzer Cell

Cathode Processes and Materials for Solid Oxide Fuel Cells with Proton Conductors As Electrolytes

Comparison of a solid oxide cell with nickel/gadolinium‐doped ceria fuel electrode during operation with hydrogen/steam and carbon monoxide/carbon dioxide

From Fundamental Interfacial Reaction Kinetics to Macroscopic Current–Voltage Characteristics: Case Study of Solid Acid Fuel Cell Limitations and Possibilities

The Effect Of Oxygen Transfer Mechanism On The Cathode Performance Based On Proton-Conducting Solid Oxide Fuel Cells

Performance Evolution Analysis of a Solid Oxide Cell Operated in Fuel-Cell, Electrolysis and Cycle Modes

Effects of regulating the cathode gas properties on the ammonia-fueled solid oxide fuel cell. Part I. Parasitic power consumption and electrical efficiency after increasing O 2 and H 2 O

Three-dimensional Structural Analyses of the Oxygen Electrodes in Solid Oxide Electrolysis Cells

Cathode Partial Pressures Estimation of A Proton Exchange Membrane Fuel Cell for Transportation Applications

Effect of the Reactant Transportation on Performance of a Planar Solid Oxide Fuel Cell

Economic Analysis of Solid Oxide Fuel Cell Systems Utilizing Natural Gas as Fuel

Performance Evaluation of Ammonia-Fueled Flat-Tube Solid Oxide Fuel Cells with Different Build-in Catalysts

Revealing and quantifying the role of oxygen-ionic current in proton-conducting solid oxide fuel cells: A modeling study

The oxygen reduction reaction in solid oxide fuel cells: from kinetic parameters measurements to electrode design

Modeling Analysis of Gas Reverse Strategy Between Symmetric Solid Oxide Fuel Cell Electrodes

Experimental and Numerical Simulation Study of Oxygen Transport in Proton Exchange Membrane Fuel Cells at Intermediate Temperatures (80 °C–120 °C)

Oxygen Reduction Electrocatalysts in Proton Exchange Membrane Fuel Cells

Analyzing and Optimizing Cathode Gas Distribution Uniformity in Proton Exchange Membrane Fuel Cell Stacks Based on Two-Phase Flow Network Model