Abstract:Small-scale nonlinear chemical and physical processes over pollution source regions affect the tropospheric ozone (O-3), but these processes are not captured by current global chemical transport models (CTMs) and chemistry-climate models that are limited by coarse horizontal resolutions (100-500 km, typically 200 km). These models tend to contain large (and mostly positive) tropospheric O-3 biases in the Northern Hemisphere. Here we use the recently built two-way coupling system of the GEOS-Chem CTM to simulate the regional and global tropospheric O-3 in 2009. The system couples the global model (at 2.5 degrees x long x 2 degrees lat.) and its three nested models (at 0.667 degrees long x 0.5 degrees lat.) covering Asia, North America and Europe, respectively. Specifically, the nested models take lateral boundary conditions (LBCs) from the global model, better capture small-scale processes and feed back to modify the global model simulation within the nested domains, with a subsequent effect on their LBCs. Compared to the global model alone, the two-way coupled system better simulates the tropospheric O-3 both within and outside the nested domains, as found by evaluation against a suite of ground (1420 sites from the World Data Centre for Greenhouse Gases (WDCGG), the United States National Oceanic and Atmospheric Administration (NOAA) Earth System Research Laboratory Global Monitoring Division (GMD), the Chemical Coordination Centre of European Monitoring and Evaluation Programme (EMEP), and the United States Environmental Protection Agency Air Quality System (AQS)), aircraft (the High-performance Instrumented Airborne Platform for Environmental Research (HIAPER) Pole-to-Pole Observations (HIPPO) and Measurement of Ozone and Water Vapor by Airbus In-Service Air-craft (MOZAIC)) and satellite measurements (two Ozone Monitoring Instrument (OMI) products). The two-way coupled simulation enhances the correlation in day-to-day variation of afternoon mean surface O-3 with the ground measurements from 0.53 to 0.68, and it reduces the mean model bias from 10.8 to 6.7 ppb. Regionally, the coupled system reduces the bias by 4.6 ppb over Europe, 3.9 ppb over North America and 3.1 ppb over other regions. The two-way coupling brings O-3 vertical profiles much closer to the HIPPO (for remote areas) and MOZAIC (for polluted regions) data, reducing the tropospheric (0-9 km) mean bias by 3-10 ppb at most MOZAIC sites and by 5.3 ppb for HIPPO profiles. The twoway coupled simulation also reduces the global tropospheric column ozone by 3.0DU (9.5 %, annual mean), bringing them closer to the OMI data in all seasons. Additionally, the two-way coupled simulation also reduces the global tropospheric mean hydroxyl radical by 5% with improved estimates of methyl chloroform and methane lifetimes. Simulation improvements are more significant in the Northern Hemisphere, and are mainly driven by improved representation of spatial inhomogeneity in chemistry/emissions. Within the nested domains, the two-way coupled simulation reduces surface ozone biases relative to typical GEOSChem one-way nested simulations, due to much improved LBCs. The bias reduction is 1-7 times the bias reduction from the global to the one-way nested simulation. Improving model representations of small-scale processes is important for understanding the global and regional tropospheric chemistry.

Improvement of the vertical mixing in chemistry transport modeling based on a 1.5-order turbulence kinetic energy-based eddy diffusivity closure scheme

Impact of Consistent Boundary Layer Mixing Approaches Between Nam and Cmaq

A one-dimensional urban flow model with an eddy-diffusivity mass-flux (EDMF) scheme and refined turbulent transport (MLUCM v3.0)

A New Scheme for the Simulation of Microscale Flow and Dispersion in Urban Areas by Coupling Large-Eddy Simulation with Mesoscale Models

Improving PM2.5 Forecasts in China Using an Initial Error Transport Model.

An urban large-eddy-simulation-based dispersion model for marginal grid resolutions: CAIRDIO v1.0

Modeling of street-scale pollutant dispersion by coupled simulation of chemical reaction, aerosol dynamics, and CFD

The use of satellite and ground based measurements for estimating and reducing uncertainties in the spatial distribution of emissions of nitrogen oxides

Exploration of the impact of nearby sources on urban atmospheric inversions using large eddy simulation

Improving PM 2.5 Forecasts in China Using an Initial Error Transport Model

Study on micro-atmospheric environment by coupling large eddy simulation with mesoscale model

On the application and grid-size sensitivity of the urban dispersion model CAIRDIO v2.0 under real city weather conditions

Development and Evaluation of the Aerosol Dynamics and Gas Phase Chemistry Model ADCHEM

A mixed layer height parameterization in a 3-D chemical transport model: Implications for gas and aerosol simulations

Development of WRF/CUACE v1.0 model and its preliminary application in simulating air quality in China

On the Modeling of Scalar Mixing Timescale in Filtered Density Function Simulation of Turbulent Premixed Flames

Evaluation of the WRF-UCM Mesoscale Model and ECMWF Global Operational Forecasts over the Paris Region in the Prospect of Tracer Atmospheric Transport Modeling

Improved simulation of tropospheric ozone by a global-multi-regional two-way coupling model system

On the influence of vertical mixing, boundary layer schemes, and temporal emission profiles on tropospheric NO2 in WRF-Chem – comparisons to in situ, satellite, and MAX-DOAS observations

Modeling of gas and aerosol with WRF/Chem over Europe: Evaluation and sensitivity study

Study on the 3dvar Emission Inversion Method Combined with Machine Learning in CMAQ