Abstract:Reasonable equipment layout is essential for creating a healthy and safe environment, especially in a three-level biosafety laboratory with high potential risk factors of infection. Since 2019, COVID-19, an emerging infection has swept the world and caused severe losses. Biosafety laboratories are mandatory sites for detecting high-risk viruses, so related research is urgently needed to prevent further laboratory-acquired infections of operators. This study investigated the effects of obstacles on exposure infection of staff in a biosafety laboratory with related experimental equipment. The numerical simulation results are highly verified by the measured results. The results indicate that although the equipment layout does not affect the bioaerosol removal time, nearly 17% of the pollutant particles in the actual laboratory cannot be discharged effectively compared with the ideal situation. These particles lingered in the lower space under the influence of vortex, which would increase the respiratory risk of operators. In addition, after the experiment a large part of bioaerosol particles would be captured by equipment and floor, and the deposition rate per unit area is 0.45%/m2 and 0.8%/m2, respectively. Although the results show that the equipment layout could reduce the pollution on the floor, the disinfection is still an important link, especially on the surfaces of equipment. Meanwhile, the result also indicates that the action should be light and slow when operating in BSL-3 laboratory, so as to avoid the secondary suspension pollution of bioaerosol particles on the equipment surface and floor.

Study on contaminant distribution in a mobile BSL-4 laboratory based on multi-region directional airflow

Study on Airflow Distribution and Energy Conservation in a BSL-4 Laboratory Involved in Aerosol Infection Risk

Spatial distribution of bioaerosols and evaluation of four ventilation method on controlling their diffusion in a typical enhanced biosafety level 2 laboratory

Infection Risk Assessment Due to Contaminant Leakage in Biological Laboratories in Different Scenarios - the Case of COVID-19 Virus

Effect of equipment layout on bioaerosol temporal-spatial distribution and deposition in one BSL-3 laboratory

Numerical Study of Airflow Pattern and Bioaerosol Dispersion During Door Motion in a Negative Pressure Isolation Ward

Potential infection risk assessment of improper bioaerosol experiment operation in one BSL-3 laboratory based on the improved Wells-Riley method

Experimental study on air distribution modes in biosafety laboratories

Airflow and Aerosol Transport in the Hospital Isolation Zone Based on Dynamic Scenarios

Mitigating aerosol-induced respiratory infections in home quarantine: The role of door dynamics and ventilation in residential design

Environmental Effects on Viable Virus Transport and Resuspension in Ventilation Airflow

Full-scale experimental and numerical study of bioaerosol characteristics against cross-infection in a two-bed hospital ward

Study on acquired infection of patients in waiting space of fever clinic

Using CONTAM to Design Ventilation Strategy of Negative Pressure Isolation Ward Considering Different Height of Door Gaps

An agent-based study on the airborne transmission risk of infectious disease in a fever clinic during COVID-19 pandemic

Influence of Different Air Distribution on Ventilation Effectiveness in Negative Pressure Hospital Wards

Study on the migration characteristics of bioaerosols and optimization of ventilation patterns in a negative pressure isolation ward considering different patient postures

Visualization of the infection risk assessment of SARS-CoV-2 through aerosol and surface transmission in a negative-pressure ward

Investigation of pathogen-laden aerosol aerodynamics and ventilation rates on their long-range transmission: A study on the Fangcang shelter hospital

A Numerical Investigation on Indoor Air Ventilation Design and Aerosol Transportation: a Case Study in a Hospital Hall

Environmental Assessment of SARS-CoV-2 for Internal Quality Management in a Clinical Laboratory