Abstract:The combination of plastic scintillators with Silicon Photo-Multipliers (SiPMs) is widely used for detecting radiation in high-energy astrophysics, particle physics, neutrino physics, or medical physics. An example of application for this kind of detectors are Compton polarimeters such as POLAR-2 or LEAP, for which a low-Z material is needed for the Compton effect to be dominant down to as low energy as possible. Such detectors aim to measure low energy Compton depositions which produce small amounts of optical light, and for which optimizing the instrumental optical properties consequently imperative. The light collection efficiency of such a device was studied with a focus on the POLAR-2 GRB polarimeter, in which the conversion of incoming $\gamma$-rays into readable signal goes through the production and collection of optical light, which was to be optimized both through measurements and simulations. The optical elements of the POLAR-2 polarimeter prototype module were optically characterized and an optical simulation based on Geant4 was developed to fully model its optical performances. The results from simulations were used to optimize the design and finally to verify its performance. The study resulted in a detector capable of measuring energy depositions of several keV. In addition an important finding of this work is the impact of the plastic scintillator surface roughness on the light collection. It was found that a plastic scintillator with a higher scintillation efficiency but made of a softer material, hence with a rougher surface, was not necessarily the best option to optimize the light collection. Furthermore, in order to optimize the optical crosstalk between different channels, a production technique for very thin ($\sim$150$~\mu$m) and reusable silicone-based optical coupling pads, which can be applied for other experiments, was developed.

Multi‐Photon 3D Laser Micro‐Printed Plastic Scintillators for Applications in Low‐Energy Particle Physics

High-resolution 3D Nanoprinting Based on Two-Step Absorption Via an Integrated Fiber-Coupled Laser Diode.

Additive manufacturing of fine-granularity optically-isolated plastic scintillator elements

Additive manufacturing of a 3D-segmented plastic scintillator detector for tracking and calorimetry of elementary particles

3D Printed Ultra‐Fast Plastic Scintillators Based on Perovskite‐Photocurable Polymer Composite

A novel polystyrene-based scintillator production process involving additive manufacturing

Additive manufacturing of inorganic scintillator-based particle detectors

3D Printing of Scintillating Materials

Sensitized Triplet‐triplet Annihilation in Nanostructured Polymeric Scintillators Allows for Pulse Shape Discrimination

Microstructured plastic scintillators for pencil beam profiling in proton-therapy accelerators

Light-sheet 3D microprinting via two-colour two-step absorption

Microstructured Plastic Scintillators For Beam Profiling In Medical Accelerators

Fast Micron-Scale 3D Printing with a Resonant-Scanning Two-Photon Microscope

3D Printed Polymer Photodetectors

Resurfaced CsPbBr3 Nanocrystals Enable Free Radical Thermal Polymerization of Efficient Ultrafast Polyvinyl Styrene Nanocomposite Scintillators

Multi-photon polymerization using upconversion nanoparticles for tunable feature-size printing

3D Printing Neutron Detectors using Scintillating BN/ZnS Resin

A fully active fine grained detector with three readout views

One step multi-material 3D printing for the fabrication of a photometric detector flow cell

Optimizing the light output of a plastic scintillator and SiPM based detector through optical characterization and simulation: A case study for POLAR-2

Large-scale self-assembled nanophotonic scintillators for X-ray imaging