Thiosulfate leaching of gold catalyzed by hexaamminecobalt(III): Electrochemical behavior and mechanisms

Yan Zhang,Bin Xu,Mingyao Cui,Qian Li,Xiaoliang Liu,Tao Jiang,Xianjun Lyu

DOI: https://doi.org/10.1016/j.electacta.2021.139393

IF: 6.6

2021-12-01

Electrochimica Acta

Abstract:Thiosulfate is a green gold lixiviant that has promise to replace cyanide at the gold mining industry. Hexaamminecobalt(III) (Co(NH3)6 3+) is effective in catalyzing the thiosulfate leaching of gold from ores, but the electrochemical behavior and catalytic leaching mechanisms remain unclear. This paper reports an in-depth investigation into the electrochemical behavior of gold leaching in ammoniacal thiosulfate solutions catalyzed by Co(NH3)6 3+. The electrochemical results suggested that Co(NH3)6 3+ is more efficient than Cu(NH3)4 2+ in catalyzing the ammoniacal thiosulfate leaching of gold. Compared with Cu(NH3)4 2+, the coulombic efficiency of gold dissolution (Q Au/Q T) under the Co(NH3)6 3+ catalysis is much higher. In the presence of Co(NH3)6 3+, the Q Au/Q T was nearly 100% at 150–250 mV and higher than 78.9% at 250–350 mV; at 250 mV, the Q Au/Q T was approximately 100% in the initial electrolysis of 300 s and remained basically unchanged at around 75% after 1200 s. Leaching results further showed that the catalysis of Co(NH3)6 3+ not only achieved a continuous leaching of gold with time, but also significantly decreased the consumption of thiosulfate from 36.5% (for Cu(NH3)4 2+) to 20.9% after leaching 24 h. In the ammoniacal thiosulfate solution, Co(NH3)6 3+ is likely reduced to mixed ligand Co(II) complexes of Co(NH3) x (S2O3)0 (x = 4, 5), which are readily oxidized back to Co(NH3)6 3+. Thus, an improved catalytic mechanism of gold leaching is proposed that the redox cycle between Co(NH3)6 3+ and Co(NH3) x (S2O3)0 (x = 4, 5) catalyzes the leaching of gold with ammoniacal thiosulfate.

electrochemistry