Construction of AgI/NH 2 -MIL-125(Ti) heterojunction: Efficient degradation of organic pollutants in water by visible light response

Zhao Wang,Ping Zhang,ReYila Tuerhong,Longjian Li,Ning Li,Xiaoping Su,Zhiying Duan,Shujuan Meng,Lijuan Han,Yuqi Han
DOI: https://doi.org/10.1016/j.matchemphys.2024.129901
IF: 4.778
2024-08-29
Materials Chemistry and Physics
Abstract:Photocatalytic technology is an effective means to convert clean solar energy into green chemical energy, which has broad application prospects. Metal-organic framework (MOFs) composites have been widely used to remove pollutants from water. In this paper, the photocatalytic effect of NH 2 -MIL-125(Ti)[NM125(Ti)] photocatalyst with different AgI content on pollutants in water under visible light irradiation were studied. The successful preparation of AgI/NH 2 -MIL-125(Ti) photocatalyst was proved by the characterization of the physical and chemical structure of the composite material. When the dosage of AgI is 0.5 mmol, the removal rate of TC by AgI/NH 2 -MIL-125(Ti) is the highest (82 %). In addition, the photoelectrochemical test also proved that AMNT-0.5 mmol photocatalyst has higher electron-hole separation efficiency. After five cycle tests, the composite photocatalyst of ANMT-0.5 mmol still has good stability. The enhancement of the performance of ANMT-0.5 mmol photocatalyst can be attributed to: (i) the introduction of AgI increases the absorption of visible light in the composite; (ii) The close relationship between AgI and NM125(Ti) accelerates the separation of electron-hole pairs, thus improving the photocatalytic performance.
materials science, multidisciplinary
What problem does this paper attempt to address?