Abstract:Microwave-induced in situ amorphization of a drug into a polymeric amorphous solid dispersion (ASD) has been suggested to follow a dissolution process of the drug into the polymeric network, at temperatures above the glass transition temperature (Tg) of the polymer. Thus, increasing the compact temperature, above the Tg of the polymer, is expected to increase the rate of drug dissolution in the mobile polymer, i.e., the rate of amorphization, in a direct proportional fashion. To test this hypothesis, the present study aimed at establishing a linear correlation between the compact temperature and the rate of drug amorphization using celecoxib (CCX) and the polymers polyvinylpyrrolidone (PVP) 12 and PVP17 as the model systems. Water sorbed into the drug-polymer compacts during 2 weeks of storage at 75% relative humidity was used as the dielectric heating source for the present drug amorphization process, and therefore directly affected the compact temperature during exposure to microwave radiation; the loss of water during heating was also studied. For this, compacts prepared with 30 wt% CCX, 69.5 wt% PVP12 or PVP17 and 0.5 wt% magnesium stearate (lubricant) were conditioned to have a final water content of approx. 20 wt%. The conditioned compacts were exposed to microwave radiation for 10 min at variable power outputs to achieve different compact temperatures. For compacts containing CCX in both PVP12 and PVP17, a linear correlation was established between the measured compact end temperature and the rate of drug amorphization during 10 min of exposure to microwave radiation. For compacts containing CCX in PVP12, a fully amorphous ASD was obtained after 10 min of exposure to microwave radiation with a measured compact end temperature of 71 °C. For compacts containing CCX in PVP17, it was not possible to obtain a fully amorphous ASD. The reason for this is most likely that a fast evaporation of the sorbed water increased the Tg of the conditioned drug-polymer compacts to temperatures above the highest reachable compact temperature during exposure to microwave radiation in the utilized experimental setup. Supporting this conclusion, evaporation of the sorbed water was observed to be faster for compacts containing PVP17 compared to compacts containing PVP12.

Physical Stability of Ibuprofen Upon Co-Milling with Caffeine and Polyvinylpyrrolidone at Room Temperature

Co-Amorphous System (Paracetamol:Indomethacin): Investigations on Physical Stability and Intermolecular Interactions

Particle size control and the interactions between drug and stabilizers in an amorphous nanosuspension system

The Effect of Cooling on the Degree of Crystallinity, Solid-State Properties, and Dissolution Rate of Multi-Component Hot-Melt Extruded Solid Dispersions

How rotational speed of planetary ball mill and polymer load influence the performance and water vapor sorption in solid dispersions composed of tadalafil and soluplus

Prediction of the physical stability of amorphous solid dispersions: relationship of aging and phase separation with the thermodynamic and kinetic models along with characterization techniques

Spray drying for generation of a ternary amorphous system of celecoxib, PVP, and meglumine

Investigation of Physico-Chemical Stability and Aerodynamic Properties of Novel "Nano-in-Micro" Structured Dry Powder Inhaler System

Influence of processing methods on physico-mechanical properties of Ibuprofen/HPC-SSL formulation

Investigation into the role of the polymer in enhancing microwave-induced in situ amorphization

Crystallization of Bifonazole and Acetaminophen Within the Matrix of Semicrystalline, Peo-Ppo-Peo Triblock Copolymers

Amorphous stabilization of BCS II drugs using mesoporous silica

Impact of Methods of Preparation on Mechanical Properties, Dissolution Behavior, and Tableting Characteristics of Ibuprofen-Loaded Amorphous Solid Dispersions

Studying the Impact of the Temperature and Sorbed Water during Microwave-Induced In Situ Amorphization: A Case Study of Celecoxib and Polyvinylpyrrolidone

The Effect of Carrier Matrix and the Method of Preparing Solid Dispersion on Physical State and Solubility of Ibuprofen

Computational Support to Explore Ternary Solid Dispersions of Challenging Drugs Using Coformer and Hydroxypropyl Cellulose

Amorphous Solid Dispersions: Implication of Method of Preparation and Physicochemical Properties of API and Excipients

Formulation and Process Design for a Solid Dosage Form Containing a Spray-Dried Amorphous Dispersion of Ibipinabant

Crystallization Kinetics and Molecular Dynamics of Binary Coamorphous Systems of Nimesulide and Profen Analogs

Effects of polyvinylpyrrolidone and poly (ethylene glycol) on preparation of ibuprofen pharmaceutical cocrystal